Happy to contribute to the build. May it serve you well!
Sent from my iPhone using Tapatalk
fredo - i assume both rear camber adjustment bolts are moving freely? if so... i would look at your RR lower camber arm to see if it's bent or not.
slater Today, 08:17 AMstunning... i love alpine white. BaT will do you well.
slater Today, 07:57 AMI haven’t been very active on here, recovering from bicep surgery. Going to be actively trying to sell now. Will post on BaT during summer if not sold
d-rod Today, 07:34 AMYesterday I purchased JP's Gruppe M intake because the one I currently have installed in my engine bay is not complete. What makes this acquisition nicer
cakM3 Today, 06:02 AMI'll check the prices again on Xometry and post the latest prices and shipping cost here. Might make sense to do a group buy, and I'd be on board to buy
///Mark_D Today, 04:37 AMThese are not carbon fiber interior trim parts. They are aluminum cube interior trim parts. Good luck on your search.
cakM3 Today, 01:45 AMThanks for doing this! I need both sides as well, so these files will be helpful!!! If you were selling these, I’d be a buyer for sure.
BavarianZHP Yesterday, 09:16 PMI am located in Dallas, 75033.
zhp4life Yesterday, 08:33 PMI am located in Dallas, 75033.
Last Post By: cakM3 Today, 01:45 AM
Recreating Missing ZHP Front Bumper Support Brackets
I uploaded the parts for a quote, qty 3 each left and right.
///Mark_D Today, 10:06 AMSplitting that total cost of $203.82 equally three ways