Printable View
Getting ready to do this on my car and Meecers car. I'm researching online but wanted to know those that have used it, how is it done?
http://www.diymybmw.com/e46/fender-rolling/
http://vorshlag.smugmug.com/Projects...371319&k=erMsW
http://www.youtube.com/watch?v=IQ_mKGRJlBU
http://www.youtube.com/watch?v=sVktP...eature=related
Seen it done and thought it looked very aggressive a nd vicious but looked great afterwards. Clean the inner gap with a pick or some bent stiff wire, that's what dw says.
Yup.
If its less than 80* outside, have a hairdryer at the ready to soften the edge of the fender where you'll be rolling (we don't want cracked paint). Don't heat the paint too much though. Then, take a turn on the tool....and roll back and forth. Take a turn on the tool, and roll back and forth. Repeat until that sheet is nice and flat.
Sent from Williamsburg, VA USA
What about any filler or stuff in the roll of the fender? Does that stuff just scrape out?
it should scrape right out. Usually its a lot of dirt stuck in there. It helps to have a friend keep a heat gun on the fender while you roll.
I only had dirt, and did not have the proverbial pita stuff, some have. I just hit it with a pick, and cleaned it put really well. Should really only take you 30 minutes per side, if its nice and warm out.Quote:
Originally Posted by derbo
Sent from Williamsburg, VA USA