That is wild and crazy %:)_&t right there!
Printable View
That is wild and crazy %:)_&t right there!
No new guesses? It's not for leaf springs
Rolled springs that are shaped like a snail that are used to support a hood need to be replaced now and then. So, you take out the rolled spring compressor! Duuuh.
Not for any kind of spring
Sheet....!
Well, there is a spring involved in this setup as a tensioner but it is nowhere near where this tool does it's job
A puller of things.
If it is a puller, the job only requires a short stroke and the spring or weight being lifted on the other end must be pretty strong or heavy judging by the length of the tool's lever arm. Hermes, by chance have you used this tool in a non-designed manner for hitting onto some stubborn/stuck item? The jaw end of the tool has got some "mushroom" formation.
I keep envisioning a button/pylon of some type rising independently through and slightly above the plane. The tool's center section sits on this button with the jaws latched onto open slots in the plane. The tool handle is pulled down and the planar surface rises up 25 to 50 mm allowing some kind of access or adjustment to be made.
Dual row timing tool, used for spinning the engine to tdc. Also used to spin to set valves
https://uploads.tapatalk-cdn.com/201...cb14e64a22.jpg
Beautiful.
Hermes 2
Zhpmafia 0
Keep em coming.