Awesome possum, my dude. Appreciate it!
Printable View
Anyone know what these plastic washers may be? The number on the bag isn't returning anything, but it looks like I bought 6 of them for something. Thumb for scale.
https://uploads.tapatalk-cdn.com/202...6d7029d167.jpg
I found it on a Ukraine BMW site, there's a 3 missing from the end of your part number. Try 51718212163. Looks like it goes on the engine plastic pan X 6
https://www.realoem.com/bmw/enUS/sho...74#51718212163
I actually replaced all the missing hardware on my belly pan in May, and bought 7 of these (the oil drain access cover uses it too)
So I think it's time to finally get a new front bumper. After plastic welding the bracket and getting it as flush as i possibly could, my brother trashed it again by pulling too far forward in a parking stall.
Question: does anyone know where i can get just the MTech II bumper cover for a coupe and none of the associated mesh, foglights, or foglight trim?
https://www.carparts.com/details/BMW...edium=surfaces
Like this, but for a coupe. And not genuine BMW lol.
Anyone know where to buy some decent carbon fiber engine covers?
I did it earlier this year. It is not fun.
I needed:
Axle remover - driver side only
Standard universal bearing press to remove and press the bearing and spindle
Race puller to remove the inner race from the spindle
I bought the axle puller from ecs and borrowed the other two from autozone.
Have you considered hydrographics/water transfer printing? https://www.lipcollision.com/services/hydrographics/