My lower steering wheel trim in my ZHP is all scratched up and I don’t want to pay $100 for a new one. Anyone selling a good condition used lower steering wheel trim? Shipping to 35758
Printable View
My lower steering wheel trim in my ZHP is all scratched up and I don’t want to pay $100 for a new one. Anyone selling a good condition used lower steering wheel trim? Shipping to 35758
You could sand and paint it.
You could sand it & wrap it with Alcantara.
My plan is to sand it and wrap it with Carbon fiber, while I'm doing the wheel cover replacement
That’s what I have now. Didn’t sand it down thoughQuote:
Originally Posted by Eugene
https://uploads.tapatalk-cdn.com/201...8e5711fd93.jpg
LOVE it!Quote:
Originally Posted by TLL0003
So it’s ok to just wrap over the plastic? Any other tips that you have for me?
If it's chipped up, you'll probably want to sand it before applying a vinyl wrap. Any imperfections will show through.
I did mine in brushed aluminum and love it
https://uploads.tapatalk-cdn.com/201...850b657e7c.jpg
I love how it matches your silver cubeQuote:
Originally Posted by ZHPizza
Think I’ll need sanding?
https://live.staticflickr.com/65535/...55da997f_z.jpg
The matching looks great! That’s what I was going for but there isn’t a vinyl that perfectly matches the black cube trimQuote:
Originally Posted by ZHPizza
Yeah I think you’d be perfectly fine to just wrap it. In my experience the vinyl was thick enough to mask any imperfection.Quote:
Originally Posted by Eugene
It’s very easy to remove the trim and pull the buttons off to make wrapping easier. Work slowly and use a heat gun or hair dryer small sections at a time. Good luck! Post a picture of the finished product
Yeah, that's not bad at all. You should be ok just to wrap that.
What pedals are those??
Sent from my iPhone using Tapatalk
Here's another option. I really like the work he did on the lower arm rests!
https://r.tapatalk.com/shareLink?url...2&share_type=t
E46 steering wheel/SMG paddles/shifter surround/trim refinishing service
OMP 1010Quote:
Originally Posted by sc330i
https://r.tapatalk.com/shareLink?url...2&share_type=t
That looks very good. The match is close enough that it wouldn't bother me.Quote:
Originally Posted by ZHPizza
I believe that's brushed aluminum all around.Quote:
Originally Posted by Eugene
I bought a Porter Cable 1500HG when it was on sale. A hair dryer would do fine, but I felt this heat gun was more friendly for n00bs like me as the heat is more adjustable. I used this wrap: https://www.amazon.com/gp/product/B0058DIDTY. Still have a ton left over.Quote:
Originally Posted by Eugene
I only did the lower trim. The trickiest parts were the curves for the spokes as the wrap needs to stretch a bit. Not sure if it's the correct way but I had to make a cut out on the edge of the wrap to make it easier to apply. Also the emblem can be slightly tricky. If you don't take the emblem off you have to work around and cut around the M logo. I ended up cutting slightly into the logo. Then I cut the four corners to apply around the edges of the logo. If you decide to remove the logo, then you have to figure out how to remove it and re-glue.
On mine I took acetone and stripped finish off then re sprayed in it black. So far it’s held up really well.
Sent from my iPhone using Tapatalk
Looks killer! Which color carbon fiber vinyl did you use? I'm looking at anthracite. Looks like it matched up pretty well with the dash panel. Plan to do same or similar with mine.
Thanks?
I think it's the one I linked above in post 15.Quote:
Originally Posted by Davo
Bummer, didn'tnotice the link. Thanks!