Search:

Type: Posts; User: sillieidiot

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    1
    Views
    51

    I feel like the SGT scorza one was the best...

    I feel like the SGT scorza one was the best fitting one of the bunch. unless you had vorsteiner. can always buy them used I guess. Not sure about the ducktail. The ones that I've seen, the angle of...
  2. Replies
    42
    Views
    4,454

    Yeah I'm done for it. Let's see if we can...

    Yeah I'm done for it. Let's see if we can actually get one going.
  3. Replies
    42
    Views
    4,454

    when is it? next month I hope? I still only have...

    when is it? next month I hope? I still only have like half a car lol
  4. SoI'm currently on a remote project and a...

    SoI'm currently on a remote project and a project at a local hospital. I have been working double shifts for the last 3 weeks. I'm so tired of this shit :crying The consequences of my actions lol I...
  5. Replies
    7,912
    Views
    1,042,885

    Do you have pictures of the face of the plug?...

    Do you have pictures of the face of the plug? instead of from the side?

    To me, the pictures you showed look like they are the female ends and that you need the male ends?
  6. Replies
    25,505
    Views
    3,420,771

    I'm pretty sure if it's your ps pump, you would...

    I'm pretty sure if it's your ps pump, you would have heavy steering too. Honestly, that noise sounds to me like it's pulleys more than tensioner. Like the bearings on the pulleys. Usually the...
  7. Replies
    25,505
    Views
    3,420,771

    Well it's a lot harder on the e46 facelift coupe...

    Well it's a lot harder on the e46 facelift coupe to do, that's for sure. especially if you're trying to do a retrofit on the bixenon headlights. It's way easier to do it on halogens. there's more...
  8. Replies
    57
    Views
    4,103

    nice updates.

    nice updates.
  9. Replies
    25,505
    Views
    3,420,771

    Yeah. It's a god send for carpool. I woke up late...

    Yeah. It's a god send for carpool. I woke up late to work. But I made up the time flying through the carpool lane lol Plus I can eat and do other stuff while the car is on AP. But yeah the car just...
  10. This is why I collect the lenses lol I think I...

    This is why I collect the lenses lol I think I have like 2 pairs. But mines never going to go bad cause I have PPF on lol I've been meaning to sell them, but too lazy to take it out of storage.
  11. Replies
    2
    Views
    65

    one of the rings, the inside one will sit on the...

    one of the rings, the inside one will sit on the top of the ring. the outer one will be outside of it. the rings will look ugly removed since there are notches. But you can take them out to paint...
  12. Replies
    11
    Views
    206

    Could be that. The hydraulic tensioner failed on...

    Could be that. The hydraulic tensioner failed on JRs car where the plastic bushing or something that the bolt goes through and it was like flapping around if you yank it around hard enough, not...
  13. Replies
    2
    Views
    126

    I think this is a dupe thread? I swear I answered...

    I think this is a dupe thread? I swear I answered this in another one lol
  14. Replies
    7,912
    Views
    1,042,885

    I swear those part numbers don't even come up....

    I swear those part numbers don't even come up. pull out a pin and the wire gauge, probably find it faster that way lol

    edit:
    I guess it's a type of PBT GF15 connector

    like these:...
  15. Replies
    11
    Views
    206

    Yes it is. That's why I tried to take care of all...

    Yes it is. That's why I tried to take care of all the crap that was under the manifold before the sc was installed lol save me some pain later.
  16. Replies
    11
    Views
    206

    since it broke right across the screw hole, I'm...

    since it broke right across the screw hole, I'm going to venture a guess that it was tightened too much at one point.

    is this the OFH side that you can take off? if so, just buy a used one and...
  17. Replies
    13
    Views
    168

    sounds good. I would have suggested against the...

    sounds good. I would have suggested against the projector fogs. they suck lol Should be fine, I think in pictures, all the lights will match. In person it'll be slightly off. the osrams would match...
  18. Replies
    18
    Views
    310

    look up the WDS and it'll tell you. If you...

    look up the WDS and it'll tell you.

    If you have a multimeter, just use continuity test to test for ground. Faster than looking it up.
  19. Sounds like a big project. It's like when I was...

    Sounds like a big project. It's like when I was working on JR's "while we're here.." project.

    If you're doing any drive line stuff, you might as well just do the transmission. What are you going...
  20. Replies
    13
    Views
    168

    LED bulbs could fit the bill for the fog lights....

    LED bulbs could fit the bill for the fog lights. You can do HID, but it really starts to mess the LCM and cluster in our cars after awhile. It still affects it even when you run a wiring harness. You...
  21. Replies
    25,505
    Views
    3,420,771

    I moved my car from 4 cars up the street to a...

    I moved my car from 4 cars up the street to a spot that is right at the beginning of the of the opening to the garages. It's parked in front of this car that never moves. Now there will be 2 cars...
  22. Replies
    18
    Views
    310

    Well at least it's working now so that's good.

    Well at least it's working now so that's good.
  23. Replies
    18
    Views
    310

    Can you post on their FB directly? If you can. I...

    Can you post on their FB directly? If you can. I would suggest you do that. That way they don't try to ignore you when everyone can see it lol

    Can you post pictures of the camera with the wiring...
  24. Replies
    18
    Views
    310

    maybe you're not activating the correct trigger...

    maybe you're not activating the correct trigger wire to make them work. That's pretty much how I would usually bench test it to see if the camera works.

    What about testing the AVIN? can you hook a...
  25. Replies
    18
    Views
    310

    Pretty much the same way you as you would...

    Pretty much the same way you as you would connecting it directly to the headunit.

    You would power the camera and the reverse wire with a 12v source. Then connect the RCAs to their respective...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4