Search:

Type: Posts; User: Vas

Page 1 of 20 1 2 3 4

Search: Search took 0.14 seconds.

  1. Replies
    49
    Views
    2,216

    Thanks !If you decide to diy it, I bought the bmw...

    Thanks !If you decide to diy it, I bought the bmw wheel bearing tool kit. It allows to press out the bearings and install them and the hub. I couldn't imagine doing it without it. Man it's was a...
  2. Replies
    49
    Views
    2,216

    And here we have 2 fully rebuilt trailing arms....

    And here we have 2 fully rebuilt trailing arms. New bearings, hubs, dust shields, m3 lower up upper ball joints and z4m rtab...
  3. Replies
    23,982
    Views
    1,847,160

    No pictures but I pressed in new rear wheel...

    No pictures but I pressed in new rear wheel bearings and hubs in the rear. Also replaced the upper and lower control arm bushings with the m3 style ball joint units.

    Sent from my Pixel 4 XL using...
  4. I liked the improvement it made but since it's...

    I liked the improvement it made but since it's poly it does require maintenance with grease. But it's not an easy part to get to.

    I removed it and rebuilt the shifter with all brand new parts and...
  5. I had the Turner Motorsports shifter carrier...

    I had the Turner Motorsports shifter carrier bushing and ended up removing it. It made noise and was annoying. Went back to the rubber oe bushing.

    Sent from my Pixel 4 XL using Tapatalk
  6. Replies
    23,982
    Views
    1,847,160

    I'm in the same situation with the parking brake...

    I'm in the same situation with the parking brake and all the hardware.

    Northern cars are the worst.

    Sent from my Pixel 4 XL using Tapatalk
  7. Thread: Engine Replacement

    by Vas
    Replies
    123
    Views
    14,038

    FYI the brake rotor backing plates can't be...

    FYI the brake rotor backing plates can't be installed without removing the hub in the rear.

    Sent from my Pixel 4 XL using Tapatalk
  8. Any chance this is available Shawn? Sent from...

    Any chance this is available Shawn?

    Sent from my Pixel 4 XL using Tapatalk
  9. Replies
    1,590
    Views
    130,892

    Recent maintenance Oil change with liqui...

    Recent maintenance


    Oil change with liqui moly 5w-30 and added a can of mos2. Also replaced the engine air filter and cabin filter with Mann brand.

    Mileage is 196,781

    Sent from my Pixel 4...
  10. Replies
    40
    Views
    815

    I would replace both parts of it. Sent from...

    I would replace both parts of it.

    Sent from my Pixel 4 XL using Tapatalk
  11. Replies
    57
    Views
    4,338

    This looks great. Sent from my Pixel 4 XL...

    This looks great.

    Sent from my Pixel 4 XL using Tapatalk
  12. Replies
    27
    Views
    1,046

    Any clue where your old zhp is? Sent from my...

    Any clue where your old zhp is?

    Sent from my Pixel 4 XL using Tapatalk
  13. Replies
    187
    Views
    34,265

    BSMhttps://uploads.tapatalk-cdn.com/20200510/29886...

    BSMhttps://uploads.tapatalk-cdn.com/20200510/298862a8b68c699070a9f32a7a8cb981.jpg

    Sent from my Pixel 4 XL using Tapatalk
  14. Replies
    27
    Views
    1,046

    Welcome back Sent from my Pixel 4 XL using...

    Welcome back

    Sent from my Pixel 4 XL using Tapatalk
  15. Replies
    14
    Views
    411

    Welcome. Sent from my Pixel 4 XL using...

    Welcome.

    Sent from my Pixel 4 XL using Tapatalk
  16. Replies
    49
    Views
    2,216

    Next up is the rebuild them. I got new dust...

    Next up is the rebuild them. I got new dust shields, bearings, hubs, parking brake assembly and rotors. Also will replace the rtab and the upper and lower bushings for the control arms. Also got new...
  17. Replies
    7,336
    Views
    514,727

    They will not. This sounds more of an issue with...

    They will not. This sounds more of an issue with the actual braking system.

    Are the same type of pads used on the front vs the rear of the vehicle? Last time a brake fluid flush was done? A...
  18. Replies
    21
    Views
    1,239

    I enjoy reading people whine about the higher...

    I enjoy reading people whine about the higher cost over a base or sport equipped car.

    Sent from my Pixel 2 XL using Tapatalk
  19. Replies
    49
    Views
    2,216

    Bought a used set of non rusted trailing arm/hub...

    Bought a used set of non rusted trailing arm/hub assembly for dirt cheap.

    Sent from my Pixel 2 XL using Tapatalk
  20. Replies
    49
    Views
    2,216

    Yeah for real. I just want a test drive and a...

    Yeah for real. I just want a test drive and a track day with it.

    Btw I removed the hard coolant pipes and right away noticed the issue. The 2 o-rings on the upper pipe were not seated properly...
  21. Replies
    49
    Views
    2,216

    Btw this is the aftermath of the trailing arm/hub...

    Btw this is the aftermath of the trailing arm/hub assembly with what should have been a simple hub and bearing job.

    I didn't even bother trying to get the hub and bearing out since there is no...
  22. Replies
    49
    Views
    2,216

    New record for me to remove the intake manifold...

    New record for me to remove the intake manifold is 35 minutes.

    Looks like the leak is from the upper hard coolant pipe.

    Either the o-ring isn't seated properly or the surface of the coolant...
  23. Replies
    49
    Views
    2,216

    Like they say when it rains it pours. Noticed...

    Like they say when it rains it pours.

    Noticed that a coolant leak developed under the intake manifold. Not sure what the deal is but now have to pull the manifold back off to see what is causing...
  24. Replies
    8
    Views
    395

    Welcome Sent from my Pixel 2 XL using Tapatalk

    Welcome

    Sent from my Pixel 2 XL using Tapatalk
  25. Replies
    21
    Views
    1,239

    79k and it's on the original cooling system from...

    79k and it's on the original cooling system from 2003. Ticking time bomb

    Sent from my Pixel 2 XL using Tapatalk
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4