Materials to Maintain Your ZHP IIIII Hand Protection IIIII Tools to Maintain Your ZHP

Search:

Type: Posts; User: rikdee

Page 1 of 8 1 2 3 4

Search: Search took 0.10 seconds.

  1. Thread: Door sills

    by rikdee
    Replies
    37
    Views
    11,827

    I purchased these for my sedan about two years...

    I purchased these for my sedan about two years past. They look great especially with my silver grey paint and black interior.
  2. I did not remove the calipers. Such would seem...

    I did not remove the calipers. Such would seem appropriate only if the calipers were for, another reason, off the car. Otherwise, what is visible with the wheels on would never require the calipers...
  3. Caliper paint Pt. III, my G2 experience doityourself

    Did wheel removal and all cleaning and prep on Friday and Saturday, about three hours each session. I got at the painting Saturday PM; it took about 3.5 hours to go around the car four times. Each...
  4. Replies
    49
    Views
    15,090

    My dealer gives me RealOEM minus 20%. Just out of...

    My dealer gives me RealOEM minus 20%. Just out of curiosity, I'll check it by sending my contact the part number.
  5. Replies
    10
    Views
    13,346

    M- Blue brake calipers, PT. II doityourself

    An exhaustive internet search has been unable to verify the paint color as Monte Carlo blue. Seems BMW is keeping the wraps on this one. At the same time, I researched caliper paint kits concluding...
  6. Replies
    8
    Views
    11,049

    new M brake caliper blue

    Anyone know the paint code or descriptive color for the new M brake calipers?
  7. Replies
    0
    Views
    1,052

    (SOLD) Timex Ironman Lap Tap Watch

    sold
  8. Thread: Windshield cowl

    by rikdee
    Replies
    35
    Views
    9,885

    wiper arm removal. Once the cap and retaining nut...

    wiper arm removal. Once the cap and retaining nut are removed, place a wash cloth or small towel beneath the hinged point on the wiper arm. Now simply press the hinged joint downward towards the...
  9. I replaced the driver exterior piece last year...

    I replaced the driver exterior piece last year via this TIS. As you cited, not too bad, but take your time with the interior window gasket getting it properly "tucked back in". Observe its removal...
  10. Replies
    78
    Views
    20,156

    When exiting the car and closing the passenger...

    When exiting the car and closing the passenger door behind you, do not place your greasy fingers on the exterior B pillar trim to close the door. Use the door handle!
  11. Thread: Car Covers

    by rikdee
    Replies
    15
    Views
    5,385

    If you're driving the car, a cover is more about...

    If you're driving the car, a cover is more about how clean or dirty the car is before the cover is deployed. I have used covers (sun protection) for years in SWFL for both dd's and cars that didn't...
  12. Replies
    10
    Views
    6,273

    Front is the same.

    Front is the same.
  13. Replies
    2
    Views
    1,763

    ID this connector please

    There is an electrical connector with three plugs that snakes over top the upper radiator hose. One of its plugs attaches to front of engine, the other two connect at the lower left front section of...
  14. Thread: Ultimate Pedals

    by rikdee
    Replies
    4
    Views
    3,449

    Yes, I installed them couple years ago. I...

    Yes, I installed them couple years ago. I purchased with the left extension, shiny anit-slip without the grip inserts. The quality is first rate; they look super nice. I have been very satisfied and...
  15. Replies
    4
    Views
    2,895

    thanks Dane!

    thanks Dane!
  16. Replies
    4
    Views
    2,895

    Oil Filter Housing Gasket

    Can anyone direct me to a good DIY, photos preferred?
  17. Replies
    8
    Views
    2,652

    Dealer said code shows failing DSC pressure...

    Dealer said code shows failing DSC pressure sensors (2), a mere $800.00 estimate. The DIY for this isn't too bad but my research shows the problem could be other things despite the pressure sensor...
  18. Replies
    27
    Views
    10,072

    Thanks to all.

    Thanks to all.
  19. Replies
    27
    Views
    10,072

    replacing oil filter housing gasket and VCG

    While we're in there for both replacements, is there anything along the way that makes sense to replace/clean/inspect?
  20. Replies
    8
    Views
    2,652

    No, only OEM fluids have ever been used in the...

    No, only OEM fluids have ever been used in the car. And yes, an OBDII code reader was used and ABS codes could have not read [part of the discovery]. We're all learning...thanks for your input.
  21. Replies
    8
    Views
    2,652

    I and my friend are quite handy under-car. I...

    I and my friend are quite handy under-car. I might let the dealer read-out any codes and quote the work. Then I'll decide whether I fix it or have it fixed. This is often my method when dealing with...
  22. Replies
    8
    Views
    2,652

    Alignment is perfect, flies as straight as your...

    Alignment is perfect, flies as straight as your jet plane! I would think a failing speed sensor would trip an FC, no?
  23. Replies
    8
    Views
    2,652

    What are the lights saying?

    From time to time when driving I get a chime and the illumination of the 'brake' in the lower right of the cluster along with the lighting of the DSC icon mid-cluster. There are no driving or braking...
  24. i got my second letters today. I fixed my '03...

    i got my second letters today. I fixed my '03 myself prior to the recall; might take the ZHP in for grins.
  25. Replies
    5
    Views
    3,081

    I'd continue experiments with various lubricating...

    I'd continue experiments with various lubricating agents lest the problem is mechanical. Vinylex or Zymol Seal come to mind.
Results 1 to 25 of 189
Page 1 of 8 1 2 3 4