Great job
Great job
On the hunt for the cleanest lowest mileage ZHP sedan!
For the engine bay I first checked all visible connections and hoses, made sure they were tight...an important first step because right before I started I found his oil filter cap was barely on...I tightened and it looks like he'd stopped turning by hand as soon as the oring bit. I snugged it all the way down and then hosed down the bay and underside of the hood with the pressure washer. the W99 was a 5:1 dilution that I sprayed liberally in sections at a time. It's quite alkaline, so it does have the ability to cause corrosion on exposed aluminum if you let it dwell too long...so I made sure to keep it wet, sprayed a section, agitated, then rinsed clean. Followed up with drying with a leaf blower afterwards to avoid unnecessary extended water exposure.
For the 108 application I simply sprayed a MF towel and wiped on all plastics and visible rubber hoses.
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
Well done mate. Your engine bay looks fantastic! Then again so does the rest of the car..
Congrats for a job WELL done !