Great discussion regarding maintenance going on here
Thank you kindly everyone! I'm updating the list here for my own reference.
Green = parts already purchased
Maintenance
Fluids
- Brake fluid: Flush every two years (previously every one year). Continue to use 1L ATE SL6-1.
- Transmission fluid: I've passed the 30k mile mark and should probably change it for cheap maintenance. Currently Redline MTL, but will try Ravenol 75W-80 stuff per this thread.
- Differential fluid: At 30k miles, should flush sometime soon. Continue to use Redline 75W90.
- Power steering fluid: Overdue by a few thousand miles (30k interval) and about one year overdue for flush (five year interval). Continue to use ATF. See below regarding power steering lines.*
Mechanical items
- Power steering lines: Leak noted previously by my mechanic. Relatively sure it's the feed line (32416774215[?]), but may also be the return hose (32416796390) or suction hose (32416750155). Should also just assess if other lines/components need to be replaced.*
- Replace idler (11287841228) and tensioner pulleys (11281748131): At least one is dying already even though they were replaced 35k miles ago.
- Rebuild DISA: Use the German Auto Solutions rebuild kit.
- Replace leaking oil filter housing gasket (OFHG, 11421719855): Will purchase recommended BavAuto Viton version from ECS here, since BavAuto was absorbed by ECS.
- Replace soft fuel lines to/from fuel filter
- Replace differential bushings: One of them (unclear which) was found to be cracked by BMW dealership during complementary inspection. Will purchase OEM rubber parts (front: 33176770788, rear: 33176751808).
- Install upper (13541438761) and lower intake boots (13541438759): Perform when installing ZHPizza's larger throttle body**
- Clean the ICV while replacing intake boots above
- Replace AC blower: Although squeaking/fluttering sound has improved, will at some point need to replace the AC blower motor
- Replace driveshaft guibo/flexdisc (26117511454) and the center support bearing (26127501257). DIY guide here.
Exterior
- Replace windshield cowl (51718232894): Cracked and weathered.
- Repair cracked/dying rear window gaskets using this guide
- Replace or renew fading side markers
Miscellaneous
- Replace spare tire: I believe mine is original and should be replaced (I think it is T125/80R17)
- Get alignment following Bimmerworld spherical RTAB installation (see below)***
Modifications
Suspension
- Install used M3 27mm front sway bar (31352229755) and install correct bushings (31352229756).
- Install front sway bar end links (31356780847)
- Install Bimmerworld Spherical RTABs.***
- Install 330Cic or Xi rear sway bar (33556751267) w/ correct bushings (33551096669)
Engine/drivetrain:
- Install ZHPizza's larger throttle body.**. Details here. Additional associated parts
- Install M3 fuel baffle (16112229656)
- Install M3 motor mounts (11812283798 [2x])
- Purchase/install LSD of some sort with 3.23 or 3.38 ratio
- Purchase/install the M56 valve cover per this thread or purchase German Auto Solutions CCV Replacement Kit
- Fabricate/install custom brake duct air scoop: Using this guide
Electronics
- Reset Xtrons PB7646BAP to factory settings to see if that'll improve speed. Otherwise consider selling and getting an Avin Avant 4.
- Recode the car as a convertible to have one touch up/down windows: Using this guide. Would also require new center console trim and window switch (61316902183)
- Install M3 gauge cluster if someone can figure out coding the shift lights for a manual, non-M car.
- Install Bavsound Stage 1 speaker kit
Interior
- Repaint the Black Cube Trim to Silver Cube trim: Using this "guide" and Precision Grey paint from Advance Auto.
- Install the euro tray (51167038323)
Exterior
- Purchase/paint brake calipers black using G2 kit
- Install used OEM Shark Fin
Last edited by BMWCurves; 08-28-2021 at 08:13 AM.
I clicked on the rear windows diy only to find out it was the one that I reposted lol
Haha, I've been there.
These are the two other threads I found tucked away in my notes somewhere: