Lighting diagram for license plate bulb

[330i Lover]

I'm installing the rear camera for the AVIN Avant 2 and I'm having trouble finding a diagram showing the different wires for the license plate lights to work. There's 3 wires going to the right side bulb and I'm needing to find a diagram showing how I can use those 3 wires to install the rearview camera. Help wanted.

[330i Lover]

Pic

[BMWCurves]

Wish I could help. Did you contact the guys over at Avin for advice?

[330i Lover]

Tommy was offline. I'll probably leave him a msg if I can't find out which is +, - and trip.

Sent from my SAMSUNG-SGH-I337 using Tapatalk

[brettbimmer]

I have not taken this apart myself, but two thoughts come to mind. You can test the wires with a multimeter to check for positive/negative current draw, depending on the meter. Second, DC current only needs two wires to function. Any chance the third wire is an additional power feed to the other license plate light? That way if the bulb went out on the one in your hand, the second light still gets power. Maybe check the other bulb housing to see what you have there.

[330i Lover]

Ok, will do, thanks.

[Johnmadd]

I would guess yellow and gray is power and brown is ground... just guessing though.

[330i Lover]

I would guess yellow and gray is power and brown is ground... just guessing though.

You were right, the brown was ground. Thanks!