FS: new valeo OE clutch and PP

[slater]

i picked this new valeo OE clutch and pressure plate up a while back but will not be using it now that i am going with the valeo SMF conversion kit.

$200 USD shipped!

[DARXIDE]

I've never r/r a clutch. Feel I need to start looking into one with 160k and a little chatter starting. I'll have to research and get smart to know what in looking at here.

Sent from my SM-T813 using Tapatalk

[slater]

I've never r/r a clutch. Feel I need to start looking into one with 160k and a little chatter starting. I'll have to research and get smart to know what in looking at here.

Sent from my SM-T813 using Tapatalk

you'll need the two pieces above, plus a new flywheel (the rubber dampers on the DMF tend to wear out and cause vibration and lots of noise at idle, so it is a good idea to replace it), and a throwout bearing. and new flywheel bolts too.

[Johnmadd]

Peter, I don't know what dmf/smf is. Can you explain please, the dumbed down explanation would be best.

[az3579]

Peter, I don't know what dmf/smf is. Can you explain please, the dumbed down explanation would be best.

SMF = Single mass flywheel
DMF = Dual mass flywheel

[slater]

SMF = Single mass flywheel
DMF = Dual mass flywheel

ding ding! thanks BP.

the idea of the DMF is to reduce drivetrain vibrations.

i haven't read any reviews on the new valeo SMF kit so i have no idea if the 24# SMF is going to chatter or not, but the lighter aluminum SMFs from JB Racing or UUC do apparently chatter a lot. but some folks think that is because of their light weight, and the fact that they are made of aluminum - apparently heavier steel SMFs don't chatter.

we'll see when i get it installed!

[slater]

2017 bump...

[cakM3]

bump for a great seller

[slater]

bump for a great seller

thanks charlie!

[nextelbuddy]

do you know if this will fit an S54?

im swapping in an S54 and getrag 6 speed transmission. looking for new clutch and flywheel.