How to enable triple blink on a 4.5 LCM using NCS Expert?

[az3579]

No cutting or drilling. The cable runs down the lip of the rear window rubber. The fin attaches right at the edge of the roof/rear window line. You can lift the lip of the seal and see the space the wire runs down and around the left side of the rear glass and through the hinge area, (you should see a small grommet there) the cable is about 3mm thick. The fin is attached by an adhesive tape that comes with it. Literally a "lick it and stick it". I can take some pics if you need, glad to help.

Is that the OE method of doing it? I always thought there was a hole there on cars that had it from the factory.

[anandoc]

How did this thread about enabling triple-blink turn into installing shark-fins etc? LOL

[terraphantm]

Is that the OE method of doing it? I always thought there was a hole there on cars that had it from the factory.

Nah, my M3 which had one from the factory just had the wire run along the rear window molding.

[Overboost]

How did this thread about enabling triple-blink turn into installing shark-fins etc? LOL

You are right, it has wandered far from triple blink. My apologies. I just like hanging with you guys...

[nextelbuddy]

How did this thread about enabling triple-blink turn into installing shark-fins etc? LOL

That's my fault lol i should get just pmd him about it. Sorry!

[anandoc]

You are right, it has wandered far from triple blink. My apologies. I just like hanging with you guys...

That's my fault lol i should get just pmd him about it. Sorry!

No worries guys! I just found it hilarious!!

[ELCID86]

I have a shark fin for sale (black) if anyone needs it.