When pulling the pins up front for added camber, do you need an alignment after or does the pin pull simply just add the same amount of negative camber to both sides with no other impact?
Anyone know the exact amount of camber gained?
Thanks.
When pulling the pins up front for added camber, do you need an alignment after or does the pin pull simply just add the same amount of negative camber to both sides with no other impact?
Anyone know the exact amount of camber gained?
Thanks.
Removing the camber pins allows the camber to be adjusted a certain amount. I don't know the exact amount.
Removing the pins should only be done in conjunction with an alignment. You need to do the alignment to make the camber adjustment any way. Why not check and adjust the toe at the same time?
I have about -1.5 with stock mounts and removed pins. Verified on the alignment I did right after.
His: 05 330 ZHP Imola Red - 07 Z4 M Coupe Imola Red
Hers: 04 330i ZSP
2004 325 M56 Steel Blue Metallic - Sold
Stephen's DD & AutoX/HPDE Build Thread
Stewart WP - Z4M LCAB - M3 trans/motor mounts - DICE MediageBridge Duo - ARC-8 17x8.5"
DrVANOS - Mason Engineering Race Strut Bar - E30 Exp. Cap - Custom Black+Beige Interior - M3 Seats
Bilstein PSS10 - Turner Sway Bars 27/21 - ECST RTAB Limiters - R.E. RSM