How did you like this kit? Did it come with instructions? How was the RTAB install?
I’m thinking about doing the Bimmerworld RTAB too.
-Chris
There’s some bad feedback on the M3Forum about the bimmerworld RTABS. Apparently the bearing is the issue. They use a cheaper bearing that causes squeaking and early failure.
Monoball RTAB Thread
http://www.m3forum.net/m3forum/showthread.php?t=584111
I would go with the Turner Monoball, CMP or the SDW RTABS.
The Turner RTAB uses a OE Bearing: Mercedes/lemforder 2043520027 Sealed ball joint.
Last edited by WOLFN8TR; 12-29-2018 at 09:57 AM.
BAV Stage 1 - BlueBus - UltraGauge - V1 - Orion V4's - ARC-8's - Brembo 996
TTFS Engine/SMG Tune/CSL 255 - SGT Headers/Sect 1/SCZA - Evolve Eventuri
VIS XTS CF Hood - CF Lip/Console/Diffuser - OE CSL Trunk - BWS 500S 9k/11k
Functionally they’re great, vehicle feels much better. The issue for me is, they’re a little too harsh for my taste. I think I’m a oem bushing type of guy, don’t need “super” handling for my daily. It is great though when I’m in a hurry and taking turns quickly. I haven’t decided if I’m going to keep them or go back to stock bushing.
Sent from my iPhone using Tapatalk
Thanks for the heads-up... I’ll check out the Turner stuff, but I’m not inclined to buy from ECS / Turner after reading about the ECS management issues.
-Chris
This kit appears to be the same and it's $80 plus $18 Shipping.
https://www.amazon.com/PMD-Products-...6NVFA2FSNKBJQY
Last edited by WOLFN8TR; 12-29-2018 at 01:07 PM.
BAV Stage 1 - BlueBus - UltraGauge - V1 - Orion V4's - ARC-8's - Brembo 996
TTFS Engine/SMG Tune/CSL 255 - SGT Headers/Sect 1/SCZA - Evolve Eventuri
VIS XTS CF Hood - CF Lip/Console/Diffuser - OE CSL Trunk - BWS 500S 9k/11k