Welcome
Sent from my SM-G955U using Tapatalk
Welcome
Sent from my SM-G955U using Tapatalk
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
Welcome!
2004 BMW 330i ZHP (52k miles), Jet Black with black leather, MFactory LSD (3.38) with Z4 cover, 18"x8.5" ET38 APEX Arc-8's (Anthracite) with 245/40 Michelin PSS', Koni Sports with factory springs and front and rear reinforcement plates, Shark Injector, Corsa TSE3 cat-back exhaust, TMS under-driven pulleys (water & steering), CDV delete, TMS CF strut brace, K&N CAI, GAS DISA rebuild, TMS pedals, Wheelskins steering wheel cover, roller tray center console, black-out grilles, and WeatherTech mats
Thanks for the link to Larry's original thread. I haven't tried PMing him but, if anyone should bump into Larry please let him know that the car is in good hands and I've adjusted the parking brake and new clips and guides are on order for the annoyingly broken sunroof shade ( both items were on his to-do list)
Found time last week to get new rubber mounted on the rears, rebuilt the DISA valve with a kit from GAS (even though it looked fine anyway), installed a GAS 1.2b coolant cap and adjusted the parking brake. Sunroof shade repair parts and new right front window regulator are on order. A new lower grille that Larry had purchased but never installed and was included with the sale (since the PO hadn't installed it either), is now installed
Pulled both headlights to inspect the reflector bowls and troubleshoot a stuck right-side shutter. Typical of the ZKW's, both are burnt and cracked through. Shutter solenoid is dead but, fortunately, stuck in low-beam position. Considering a ZKW Retro-Qwik kit with Morimoto Mini D2S 4.0 projectors and Nightbreaker bulbs from Lightwerkz. $242 shipped. Anyone have a suggestion on anything different or better?