I want to replace my water pump with a Stewart, & replace the factory thermostat with a Zionsville
lower temp (80deg C =176F) & I want to replace the mechanical puller fan with a oem 6spd puller.
Question, do I need to reprogram the computer so it will turn on the elec fan at a lower temp than
what the factory wanted (much hotter).
I'm trying to think this through before I buy all the parts, it seems like the new pump & thermostat
will initially make the water cooler but not for long because the factory electric fan settings wont allow
the fan to turn on until the water reaches the hot temp the factory wants.
Any advice is much appreciated, as I'm not sure what to do next .

And to complicate maters, I would like to retain my front pusher fan. I read the thread on this board by >
Mechanical Fan to Electric Fan Swap (Automatic's) doityourself I think its really good & accurate info But
where I live,last summer it was 117deg, I just cant believe only one puller fan could do the job.
I was going to wire up the front pusher fan with a separate toggle switch or get a aftermarket adjustable
thermostat and set the turn on temp where needed.
Any thoughts ?
Thanks !