Today ended up being an amazing day so I took some time to finish off a recent retrofit. It came down to a 30A fuse in my fuse panel so I replaced it. Everything checked out and I turned my car on, pressed my rear sunshade button and watched everything work as if it was originally installed. Very satisfying to see this rare option installed on my ZHP working like it should
This retrofit was not too difficult to install. For me making up the long wiring harness then using BMW cloth tape to wrap it up was the hardest part of this retrofit
Sent from my iPhone 11 Pro Max using Tapatalk Pro
Last edited by cakM3; 05-16-2022 at 03:04 PM.
looking good charlie!
-Daniel
OEM BMW Performance (Missing cams and seats)
LEVEL ONE // Euro Techniks
Auto -> 6 Speed complete
I can't say enough for this product when cleaning my alcantara steering wheel It just works
there was enough dirt still left on my steering wheel so I lathered up the steering wheel in sections and used clean fresh microfiber cloth, orange in this case, to wipe off the solution. as you can see it took off the dirt from my steering wheel
my steering wheel is now clean ready to install once it dries up
Sent from my iPhone 11 Pro Max using Tapatalk Pro
Sonax is such a good product
2005 BMW 330i ZHP - BMWP brakes/intake/strut bar/shifter, Coby wraps interior, BBS CHs, Eagle Eye LED tails, LED fog lights, GC coilovers, Sprint Booster/sport button mod, 4.5 LCM w/ programming, Xtrons 9inch HU, BSW stg1, dynamat, M3 sedan dead pedal, oCarbon CF interior trim, CF seat backs, 2x2 CF MTECH2 diffuser, CF cabin filter cover
It's raining today so I'm prepping one of my OEM M3 mirror base plates to get it trimmed up for sedan fitment
Per Rogue Engineering DIY you leave 1/8" exposed on the posts to trim off.
Next on the longest part of the baseplate You mark off 5/32" at the bottom and mark off 1/8" at the top then tape off that edge trying to follow the curvature of the baseplate as best as you can.
The last part in taping off the mirror baseplate for sedan fitment is the upper back part of the baseplate where my finger is pointing to . . .
For this part you start 2.9" from the top and line the tape from the edge at that point to the 1/8" point on the top then you're done marking everything off
It should look like this.
Now you're ready to trim your baseplate
I also updated my M3 side mirror retrofit DIY . . .
Sent from my iPhone 11 Pro Max using Tapatalk Pro
Last edited by cakM3; 05-19-2022 at 12:56 PM.
good work charlie! always very informative
-Daniel
OEM BMW Performance (Missing cams and seats)
LEVEL ONE // Euro Techniks
Auto -> 6 Speed complete