Materials to Maintain Your ZHP IIIII Hand Protection IIIII Tools to Maintain Your ZHP
Results 1 to 5 of 5
  1. #1

    DIY Dice Mediabridge Radio Interface for BMW E46

    I originally posted this on the KC BMW Club forum.....
    adding it here as well......

    Want bluetooth in your e46? How about iPod? Sirius Satellite? Oh, and an auxiliary input?

    The Dice Mediabridge was just released and will meet those needs.
    The device can be installed either in the trunk (referred to as trunk interface),
    or at the radio (referred to as radio interface). This install did not include the Sirius Satellite interface.


    This review/DIY refers to the radio interface version.

    First, let's look at what you get:



    From left to right:
    microphone
    firmware update cable
    mediabridge unit
    iPod cable (extra)
    wiring harness
    USB extension cable (can be used in place of iPod as a source)



    Here's a shot of the connectors on the Mediabridge.

    From top to bottom:
    interface connection
    USB/iPod port
    Sirius Satellite Radio
    Auxiliary Input
    Microphone input



    Here's a shot of the wiring harness.

    Begin by removing the trim on the passenger side:



    There will be four attachment points, work each one loose and the trim panel will pop off.



    The center trim panel can then be removed, there is only one attachment point for it.



    Remove the two screws and the radio will slide out.



    Remove all connections from the back of the radio - mine had two.
    One large harness for the radio, and a small single pin connector for the antenna.



    I didn't get any really good pictures of this, but next I removed the glove box.
    There were six screws around the edges of the glove box, then I had to pop it
    forward and it slid right out.



    Glove box removed and sitting on passenger floor.



    I did a quick connection and test to make sure everything was working.
    A successful test completed, I then disconnected the unit and began running
    the microphone cable. I wanted to install the microphone in the factory
    location, which is in the same panel that houses the homelink transmitter and sunroof switch.

    I began running the wire up the outside of the passenger A pillar.







    After I brought the wire up the A pillar, I then ran it up into the headliner and over to the
    center panel. I removed the panel, fed the microphone through the headliner, and then hid
    the cable.



    Microphone installed in factory location, all wiring hidden, panel reinstalled.



    I also finished tucking the wire along the outside of the A pillar down past the dashboard
    and then brought it into the glovebox area.

    Next, I removed/loosened the center vents, HVAC control unit, and the frame for the radio and HVAC.
    Removing the center vents took some work - various forums warned me they would be tightly attached
    and they were right!

    I used my interior panel pry tools, and a small screwdriver (taped up to protect the interior) to
    wiggle the vents free. Once the top two corners were free, I lifted/wiggled the bottom of the
    vents until they finally came loose. Here's a picture of the vents removed.



    I also removed the sunglasses cubby and temporarily moved the HVAC control unit out of the way.
    To remove the sunglass cubby, simply reach inside the cubby and pop up while pulling toward you.
    The panel will disengage and come right out.

    Removing the HVAC panel was simple as well, simply push from behind the panel and it will slide forward.



    There are two screws to remove the carrier which holds the radio and HVAC unit.
    These screws are located below the HVAC unit.



    With the carrier slid forward, I could then reposition the factory harness connector for the radio.
    I moved it up and to the left of its original position.



    Sorry, no pictures of these steps - my photographer was not available!
    I then fed the wiring harness for the mediabridge above and behind the carrier.
    I connected the Mediabridge harness to the factory harness for the radio.
    I removed the blue clip from the cd changer cable in the factory harness and
    placed it on the harness for the Mediabridge and secured the replacement cable.

    I then connected the Mediabridge.

    Here's a couple shots of everything put back together and tested.





    So, after all that - what's the verdict?
    I opted for the radio interface as I thought it would be easier than having to run a cable
    all the way from the trunk cd changer interface to the front of the car.
    Now, after having done the install, I think it might be a wash.
    While it would probably be more work running that cable forward, and positioning the mediabridge
    device; there's absolutely no room to work in the dash area. Feeding the cables in and
    out took forever.

    Also, I did several test fits and had some issues with the harness connector on the back of the
    radio. That plastic has been through a few heat cycles and cracked while I was fiddling with it.
    If the radio side of the connector breaks, the only option is to replace the radio.
    For now, the connection is holding well.

    So, the tradeoff is fiddling around in the dash or running a cable from the trunk.

    Difficulty of install: 6 out of 10. I'm rating it slightly above average (with one being easiest)
    simply because of the confined workspace, the difficult harness connection (BMW loves their cam-lock
    connectors) and running cables in the dash. Interior disassembly on the e46 has come a long way
    from the e36, and is very easy. I'm always fearful of removing trim in the e36 because it all feels
    like it was designed to be installed once. The e46 interior does not feel this way.

    Performance:
    The device functions as advertised. I did not test the auxiliary input or the Sirius satellite radio
    connection. I did test the USB/iPod interface, and the bluetooth interface. Both worked very well.
    The system announces what you are listening to when using iPod, and will announce callers when your
    phone rings or you dial a number.

    Bluetooth streaming worked very well and I was happy with the sound quality. Using the phone also
    worked without any issues; callers reported they could clearly hear me and there was no echo. The
    time involved in installing the microphone in the factory location is really worth the effort as
    its shielded from wind and noise, plus its totally hidden.

    The unit is somewhat particular about the process of going into its built-in setup mode. I did have
    some problems getting the unit to respond to setup mode requests. You can use the setup mode to do
    things like program how long it'll charge an iPod when the car is shut off, how quickly it scrolls
    data across the radio, and other items like volume, etc.

    The install guide/instruction manual is bare bones and could stand some improvement. The device
    is sold through EAS - European Auto Source - they have been
    very responsive and helpful during the purchase process. I'll report back on their response regarding
    some of the concerns/issues I noted.

  2. #2
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Good deal. I admire the effort here.
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  3. #3
    i spend a lot of time in the car, and i wanted something that would run the iPod, let me use Bluetooth, etc......
    i didn't want to put an aftermarket unit in, and didn't want to mess with an aftermarket double-din.
    the dynavin radio was just on its first generation when i decided to go with the mediabridge.
    probably the best thing about the mediabridge since installing is that they've released several firmware revisions which add features, fix minor issues, etc.....

    every time i do something like this though, i realize just how much i hate taking apart car interiors.....give me a motor swap anytime!
    - now with 5 speeds

  4. #4
    Join Date
    Jan 1970
    Posts
    15,433
    Just getting through some of these threads now. Thanks for posting this up, Shadow.

  5. #5
    Join Date
    Jan 1970
    Location
    Asheville, NC
    Posts
    2,591
    great thread. going to have to look into this. i want blue tooth. I already have an isimple run from the trunk for the ipod, but this looks cleaner and more functional.....thanks for the write up.
    "No, Donny, these men are nihilists, there's nothing to be afraid of"

    09 135i Msport 6mt
    04 330i ZHP (sold)
    David

Similar Threads

  1. For Sale: OEM BMW Navigation unit, DVD drive, BM53 Radio etc.
    By Nivo in forum ZHP-Related Parts & Accessories (no vehicle sales)
    Replies: 3
    Last Post: 09-29-2011, 03:21 PM
  2. Dice Mediabridge vs USA Spec
    By 2004_blue_zhp in forum General -- ZHP Related
    Replies: 13
    Last Post: 07-11-2011, 08:16 PM
  3. Trusted electronics installer in/around NYC? (For Dice Mediabridge)
    By 2004_blue_zhp in forum General -- ZHP Related
    Replies: 0
    Last Post: 05-10-2011, 03:07 AM
  4. BMW E46 Business CD Radio code
    By az3579 in forum General -- ZHP Related
    Replies: 6
    Last Post: 01-07-2011, 04:08 PM
  5. BMW Radio pixels missing randomly
    By Tampa330i in forum General -- ZHP Related
    Replies: 3
    Last Post: 12-04-2010, 08:29 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •