Several ZHP and 330i partouts- many parts available!

[squashman702]

Thanks for checking, looks like it would have the ribbon cable mirrors so I'll have to keep searching.

Sounds good- I'll verify when I pull them.

[TXRedDevil]

Dave,

Looking for:

- chrome kidney grills (clips must be intact)
- alarm system w/ brackets and nuts/bolts
- driver's side turn signal housing (rubber gasket must be in above avg shape)

Let me know if you have these. Thanks!

[squashman702]

Dave,

Looking for:

- chrome kidney grills (clips must be intact)
- alarm system w/ brackets and nuts/bolts
- driver's side turn signal housing (rubber gasket must be in above avg shape)

Let me know if you have these. Thanks!

I think I may have a turn signal somewhere- I don't have an alarm or chrome kidneys.

[TXRedDevil]

Hi Dave,

I found the above parts yesterday. Thanks for looking.

By chance do you have a black intact center console? My ashtray louver fins are 1/2 gone and the lid's arm is busted on one side.

[squashman702]

Hi Dave,

I found the above parts yesterday. Thanks for looking.

By chance do you have a black intact center console? My ashtray louver fins are 1/2 gone and the lid's arm is busted on one side.

All of the consoles I have at the moment are in rough shape.

[GeorgeH]

I don't have any good B pillars at the moment- the latest car I bought had the fabric removed already.

That is perfectly fine, all I need is the black slider part. How much shipped to 78613 for the pair?

[GeorgeH]

With that said if you have more in similar condition, with the fabric peeling, I'll take every single one you have.

[///Mark_D]

Bit of an odd request. I'm hoping you have a junk ZHP sedan bumper laying around that you could remove one of the lower mounting tabs. Just need the left hand side lower tab that fills the gap between the bumper and the lower inner fender (pork chop). Both tabs are broken off on my bumper, and I have the RH side as pictured below, but the LH side is missing.

These small mounting tabs are normally melt welded as part of the bumper assembly, so there is no individual part number. It would need to be cut free from the main part of the bumper severing the small mounting tabs where it is attached to the bumper.

Do you (or anyone else) have a junk bumper laying around that you could harvest this part from it for me? Need the left hand side only.

Thanks!

[squashman702]

Bit of an odd request. I'm hoping you have a junk ZHP sedan bumper laying around that you could remove one of the lower mounting tabs. Just need the left hand side lower tab that fills the gap between the bumper and the lower inner fender (pork chop). Both tabs are broken off on my bumper, and I have the RH side as pictured below, but the LH side is missing.

These small mounting tabs are normally melt welded as part of the bumper assembly, so there is no individual part number. It would need to be cut free from the main part of the bumper severing the small mounting tabs where it is attached to the bumper.

Do you (or anyone else) have a junk bumper laying around that you could harvest this part from it for me? Need the left hand side only.

Thanks!

I'll take a look- I might have it on the car I just bought, although it took a decent hit in the front.

[GeorgeH]

Dave, did you see my post asking about the b-pillars? I don't need them with fabric, I only really need just the black slider.