Dave,
Looking for:
- chrome kidney grills (clips must be intact)
- alarm system w/ brackets and nuts/bolts
- driver's side turn signal housing (rubber gasket must be in above avg shape)
Let me know if you have these. Thanks!
-Dave
2004 330i ZHP sedan- 6 speed swapped, Corsa exhaust
1997 AW 328i- S52 swapped
2004 IR 330i ZHP 6MT- aFe Stage 1, Shark Injector, RE Underdrives, Dforce LTWs- SOLD
1997 Technoviolet M3/2/5- LS1/T56 swapped- SOLD
Hi Dave,
I found the above parts yesterday. Thanks for looking.
By chance do you have a black intact center console? My ashtray louver fins are 1/2 gone and the lid's arm is busted on one side.
-Dave
2004 330i ZHP sedan- 6 speed swapped, Corsa exhaust
1997 AW 328i- S52 swapped
2004 IR 330i ZHP 6MT- aFe Stage 1, Shark Injector, RE Underdrives, Dforce LTWs- SOLD
1997 Technoviolet M3/2/5- LS1/T56 swapped- SOLD
Current Garage... '00 R11S, '09 HP2S, '12 R12GSA, '00 Black 323iT (wife's), '02 Alpine 325iT (Eileen, Track Wagon), '02 Japan Rot 325iT
Instagram @ HillPerformanceBimmers
Email to George@HillPerformance.com
With that said if you have more in similar condition, with the fabric peeling, I'll take every single one you have.
Current Garage... '00 R11S, '09 HP2S, '12 R12GSA, '00 Black 323iT (wife's), '02 Alpine 325iT (Eileen, Track Wagon), '02 Japan Rot 325iT
Instagram @ HillPerformanceBimmers
Email to George@HillPerformance.com
Bit of an odd request. I'm hoping you have a junk ZHP sedan bumper laying around that you could remove one of the lower mounting tabs. Just need the left hand side lower tab that fills the gap between the bumper and the lower inner fender (pork chop). Both tabs are broken off on my bumper, and I have the RH side as pictured below, but the LH side is missing.
These small mounting tabs are normally melt welded as part of the bumper assembly, so there is no individual part number. It would need to be cut free from the main part of the bumper severing the small mounting tabs where it is attached to the bumper.
Do you (or anyone else) have a junk bumper laying around that you could harvest this part from it for me? Need the left hand side only.
Thanks!
-Dave
2004 330i ZHP sedan- 6 speed swapped, Corsa exhaust
1997 AW 328i- S52 swapped
2004 IR 330i ZHP 6MT- aFe Stage 1, Shark Injector, RE Underdrives, Dforce LTWs- SOLD
1997 Technoviolet M3/2/5- LS1/T56 swapped- SOLD
Dave, did you see my post asking about the b-pillars? I don't need them with fabric, I only really need just the black slider.
Current Garage... '00 R11S, '09 HP2S, '12 R12GSA, '00 Black 323iT (wife's), '02 Alpine 325iT (Eileen, Track Wagon), '02 Japan Rot 325iT
Instagram @ HillPerformanceBimmers
Email to George@HillPerformance.com