I have significant water beading inside my driver's side tail light. Is there anything that can be done about this?
I have significant water beading inside my driver's side tail light. Is there anything that can be done about this?
Ensure the light is sealed/seated and the gasket looks good?
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
^^^ +1
Do you have any cracks in your tail light?
May need to pick up another tail light...
Hankook Ventus V4's 205/55/16 | 16" BMW OE Style 45's | ECSTuning 15mm Spacers | Thule 45050 Crossroad Rack | Thule 870XT Fairing | LLumar 35%/20% Tint
Custom Vienna Austria Euro Plate | GoMiniGo "No-Holes" License Plate Bracket | Smoked License Plate Cover | Black License Plate Frame | Khoalty LED License Plate Lights
I think there's something wrong with the driver's side tail lights. I have the same thing, and have noticed on other cars same thing has occurred. If only someone had pass side damage we could split the costs of a new taillight as the led lights are rather expensive.
Yeah I'm sure it's a seal issue, but how would I get the existing moisture out??
2004 Alpinweiss 330Ci ZHP 6MT
You could unbolt the tail lamp from the car... There's only (3) 10mm? nuts holding the tail lamp on.
While it's off, you can verify the gasket.
Is the lamp original?
The lense can be taken off without damaging it? I've found they're ussualy glued together, but then again I've never worked on a BMW tail light so that may be a false assumption. I believe it to be original, but I just bought the car and know nothing of the history. It's an LED tail light, the salesman said it's factory. I'll pull it tonight and see what I can do.
2004 Alpinweiss 330Ci ZHP 6MT
No, the lens is not removable from the assembly, as it's permanently glued.
LED's would make this issue tricky, as the whole tail lamp assembly is pretty much sealed. There aren't holes in it like the normal bulb counterparts have.
Well, I pulled it last night and the seal was bad at the top edge of the light. I was actually able to flip the light over and let the moisture slowly drip out. There is still a little bit of moisture in the light but much better.
So these LED tail lights are not stock?
2004 Alpinweiss 330Ci ZHP 6MT