Does anyone have the correct p/n for the vent window seal?
http://www.realoem.com/bmw/showparts...87&hg=51&fg=05
I'm having a hard time figuring out which one is correct. I think it's 51368252621
Does anyone have the correct p/n for the vent window seal?
http://www.realoem.com/bmw/showparts...87&hg=51&fg=05
I'm having a hard time figuring out which one is correct. I think it's 51368252621
2004 Alpinweiss 330Ci ZHP 6MT
That gasket is the one that wraps around to the inside of your car. It depends on the color of your interior. If you look at the description by the part number, it has the color listed. I'm sure that they all would fit without issue, it's just which color matches.
19" VMR VB3 CSL reps w/ General G-Max 3 A/S, BMW Performance short throw shifter, CDV delete, M54B30 swap, and a redneck CAI.
Hmmmm... so which one is the standard black rubber seal?
2004 Alpinweiss 330Ci ZHP 6MT
Disregard, I found it at ECS tuning.
2004 Alpinweiss 330Ci ZHP 6MT
I'm going to need to replace the seal on my driver's side rear window, is this an easy DIY? I'm not mechanically gifted.
Well, now that I've had it apart and replaced the seal, I've realized that the piece that is damaged is not part of the vent window seal and may actually be part of the black trim that surrounds the windows.
Am I correct? Here is a picture of the rubber seal I'm looking to repair, it's the little piece of rubber that's hanging at the lower right hand corner.
2004 Alpinweiss 330Ci ZHP 6MT
Yes, that's part of the outside window trim, and its quite pricey. The lower straight piece is about $70, the upper piece is over $700 as it wraps from the back of the rear side window all along the drip rail to the front edge of the front door. Someone had it on special recently (maybe Tisher, think it was about $600 for the two pieces) but its still awful expensive.
Bruce
21 GMC Sierra - mine
16 X5 M-Sport - wife
11 M3 - 1st son
04 Tundra - 2nd son
17 X1 M-Sport - daughter
Former (mo/yr sold):
15 335xi M-Sport (8/18)
11 335is (8/17)
11 X5 AW/blk (11/15)
04 330xi blk/gray (7/15)
06 ZHP SGM/blk (6/15)
08 335xi blue/blk (4/15)
04 ZHPci MB/blk (2/14)
04 ZHPcic IR/Alc (10/13)
01 540iT anthra/blk (7/13)
04 ZHPci TIAG/blk (9/12)
03 540i M-Sport (9/12)
01 325ci (3/12)
02 325iT 5MT (10/11)
05 ZHPci (7/11)
03 330cic (2/11)
00 323ci (10/10)
Awesome. Well, it's going to stay that way then.
2004 Alpinweiss 330Ci ZHP 6MT
Yeah, lots of us have learned to live with it.
Bruce
21 GMC Sierra - mine
16 X5 M-Sport - wife
11 M3 - 1st son
04 Tundra - 2nd son
17 X1 M-Sport - daughter
Former (mo/yr sold):
15 335xi M-Sport (8/18)
11 335is (8/17)
11 X5 AW/blk (11/15)
04 330xi blk/gray (7/15)
06 ZHP SGM/blk (6/15)
08 335xi blue/blk (4/15)
04 ZHPci MB/blk (2/14)
04 ZHPcic IR/Alc (10/13)
01 540iT anthra/blk (7/13)
04 ZHPci TIAG/blk (9/12)
03 540i M-Sport (9/12)
01 325ci (3/12)
02 325iT 5MT (10/11)
05 ZHPci (7/11)
03 330cic (2/11)
00 323ci (10/10)
I had this issue with my M3 and I can say that the trim piece did not cost $700.
The rubber gasket that is pictured is part of the entire trim piece for coupes. The trim piece (at least for my M3) cost me somewhere around $230 when I purchased it from my dealership.
The lower piece ran somewhere around $30 when I priced this part at the dealership.
I can't imagine this part costing more than that for ZHP coupes...