HELP ASAP! Tire size question!

[Johal E32]

Square setup, 18x9's all around, 255-35-18, Et: 42. My car is barley dropped on hr springs, and billy sports.

I think I might need to roll the the lip of my fenders? Or will I need spacers and a fender roll?

I am asking if this setup will work on the front and rear of my car. It should fir the rear fine. But the front should work with little modification, right?

Also, will this setup work in a year when I give my car a modest drop on ST coils?

Thanks in advance!

-Jordan

[Meric]

It will fit dont worry and you dont need to work on front end to make some little adjustments it will fit..

[Johal E32]

Cool, thanks Meric!

[derbo]

You may need to roll the rear fenders depending on how low you decide to drop. The fronts will fit fit. Just make sure it will clear the struts on the inside. I believe some rims will BARELY clear and need a 3-5mm spacer in the front.

[nike001]

Yeah the rear will fit.

Not sure how it'll be in the front. Derek mentioned you might need a spacer.. but I think you'll already be on thin ice with the offset and potential poke you may have w/o the spacers.

[Johal E32]

Thanks for the input guys.

I decided on the oem zhp tire specs. Staggered set-up, 225-40-18 and 255-35-18. I decided on some BBS LM reps wrapped in Michelin Pilot Sport A/S. 45,000 mile tread wear warranty FTW!!