For Sale (SOLD): BMW Black Euro tray (short) $45 shipped

[Hermes]

There is def gonna be some fab work to do that, with how it clips in and I think the trays aren't exactly perfect rectangles but shaped to fit the console. Might not even be enough room total... you would probably have to make something completely from scratch

[Hermes]

ok, some quick photos to show you what I mean. Do you see how it angles up towards the back armrest area (front cupholder is in line with really long piece at end of coin tray). You could custom make a tray in the back that would be REAALLLY big, but it would have to be custom.

[jreyes19]

hmm wow that would be a bit of fabrication but if done correctly it could have an amazing effect on the interior
so it would be euro tray then, cut the cup holder in a way (with the small slope so that it fits snuggly?

[Kudos]

That's exactly what i want to do. keep the front cupholder shape, the rear euro tray shape (if possible) no coin tray, and hope it fits. So what i would love is if the OP would take out eurotray and put it in the slot with cupholder next to it so i could see spacing. If it fits, i want dibs please.

[jreyes19]

so what would you like?
the euro tray installed, with the cupholder sitting next to it?
the small euro tray and oem cup holder are the same length

[Kudos]

i would need half the cup holder so only can hold one cup and the euro tray behind it.

but ya, just how you posted it.

[jreyes19]

ok will snap some tomorrow for you
and post them up

[Hermes]

so what would you like?
the euro tray installed, with the cupholder sitting next to it?
the small euro tray and oem cup holder are the same length

I think he means cut the second cupholder off and put start the euro tray from that point. I think you'll still need to do a lot of fab work to get it to fit right. You might want to figure out how youre gonna get the euro tray in first before you start cutting up your cupholders

[Kudos]

My cupholders are already scratched to hell, it'll be a nice project to keep me busy. Time to buy a dremel

[jreyes19]

ok i couldnt get pictures today
but the only thing i see that needs done is



measuring the back angle to cut both sides of the euro tray
then once in place measure the space left then cut the cup holder accordingly (more or less in half)

since there is no tilt in the console as a whole and all sides are the same height, it should work perfectly


just cutting cup holder and angle on euro tray


EDIT: also cut a small angle on the other side of the 1 cup holder to fit in with the front of the euro tray
it is a relatively small angle