Materials to Maintain Your ZHP IIIII Hand Protection IIIII Tools to Maintain Your ZHP
Page 3 of 6 FirstFirst 12345 ... LastLast
Results 21 to 30 of 60
  1. #21
    Join Date
    Jan 1970
    Location
    32.8 N, 117.3 W
    Posts
    7,640
    Quote Originally Posted by das boots View Post
    I will be getting a Bentley's soon.
    if you have an older computer just download/install the Technical Information System from this thread

    http://www.zhpmafia.com/forums/showt...G-GER-Download

  2. #22
    Join Date
    Jun 2011
    Location
    Alexandria, VA
    Posts
    28
    I bought a pair of lenses from Khoalty. I was actually very impressed with the quality and fitment...even more so considering the cost savings. The ZKW and AL lenses should be interchangeable. It's the actual projector assemblies that differ. If you have headlight washers like I do, you do not need to remove the headlight from the car to swap out the lenses. There is more than enough room to pull out the lower trim piece with the attached washer to unclip the lense. A good tip when installing new lenses is to use a q-tip and dip it in any all purpose cleaner and use it to clean out the headlight lense gasket. I did this and I've had no problems with condensation inside the lenses, even in the heaviest of downpours.

  3. #23
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Thanks Titanium
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  4. #24
    Join Date
    Jul 2011
    Location
    North San Diego, Las Vegas
    Posts
    1,959
    Quote Originally Posted by titaniumair View Post
    I bought a pair of lenses from Khoalty. I was actually very impressed with the quality and fitment...even more so considering the cost savings. The ZKW and AL lenses should be interchangeable. It's the actual projector assemblies that differ. If you have headlight washers like I do, you do not need to remove the headlight from the car to swap out the lenses. There is more than enough room to pull out the lower trim piece with the attached washer to unclip the lense. A good tip when installing new lenses is to use a q-tip and dip it in any all purpose cleaner and use it to clean out the headlight lense gasket. I did this and I've had no problems with condensation inside the lenses, even in the heaviest of downpours.
    Would you remember the price of the lenses from Khoalty? Did you specify during your purchase that you were looking for either ZKW or AL?
    Lawrence
    "But Mama....That's where the fun is!"
    BMW CCA #192742
    San Diego & Sin City Chapter
    NRA Lifetime Member

    STABLE
    '90 M3 AWII - Garage Queen (The Crown Jewel)
    '20 X5 M Sport Tourquis Blue - #3 Son Ride
    '23 X5 M Sport Sapphire Black - #1 Son Ride
    '23 X5 M Sport Mineral White - Daughter & Grand Kids Ride
    '24 X4 M40i Brooklyn Grey - SO's New Ride
    '05 330i ZHP Mystic Blue Metallic 6 spd - My Ride
    '03 Nissan Frontier XE Crew Cab - Hauler & Down Range vehicle

  5. #25
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Quote Originally Posted by das boots View Post
    Would you remember the price of the lenses from Khoalty? Did you specify during your purchase that you were looking for either ZKW or AL?
    They are depo.

    HTC Thunderbolt+TT
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  6. #26
    Join Date
    Feb 2011
    Location
    Seacoast, NH
    Posts
    832
    Quote Originally Posted by danewilson77 View Post
    They are depo.

    HTC Thunderbolt+TT
    Good reason not to buy them. I so dislike the Depo P46s I have. Can't wait to go back to stock headlamps.
    "The server is too busy at the moment. Please try again later."


    2009 Horizon Blue Mini R56 Cooper S 6spd
    2012 Pepper White Mini R56 "Justa" Cooper 6spd
    On the hunt for an e30, z3, or 318ti...


  7. #27
    Join Date
    May 2011
    Location
    A,GA
    Posts
    994
    Yeah, the price is much higher but I'm pretty happy I have oem plastic in there.

  8. #28
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Quote Originally Posted by mikeyb74 View Post
    Good reason not to buy them. I so dislike the Depo P46s I have. Can't wait to go back to stock headlamps.
    Naa...then lenses are fine. I have them. I burn through a set about once a year regardless of who makes them.
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  9. #29
    Join Date
    Jun 2011
    Location
    Chapel Hill, NC
    Posts
    2,292
    Quote Originally Posted by danewilson77 View Post
    Naa...then lenses are fine. I have them. I burn through a set about once a year regardless of who makes them.
    Once a year? Do they crack on you or what? That seems like a really short life for lenses.
    -Chris-

    2003 ZHP Sedan - Jet Black on Sand - SOLD

  10. #30
    Join Date
    Jan 1970
    Location
    Branford, CT
    Posts
    16,055
    Quote Originally Posted by danewilson77 View Post
    Naa...then lenses are fine. I have them. I burn through a set about once a year regardless of who makes them.
    Lamin-X should help extend the life of your lenses.

    Sent from my DROIDX using Tapatalk
    BP
    2005 330i ZHP / 6MT
    Imolarot / Naturbraun
    2003 330iT / 6MT
    Orientblau / Naturbraun




    It's not the car you drive, it's how you drive it.

Page 3 of 6 FirstFirst 12345 ... LastLast

Similar Threads

  1. 3M Headlight restoration kit review/DIY
    By ZSP-Mafia in forum Product and Storefront Reviews
    Replies: 25
    Last Post: 01-03-2012, 04:30 PM
  2. Carbon-Effects: BMW E46 Carbon Fiber Valve Cover and Fuel Rail Cover
    By kayger12 in forum Product and Storefront Reviews
    Replies: 32
    Last Post: 10-14-2011, 03:10 PM
  3. For Sale (SOLD): D90 Nikon camera + 18-200mm VR I Nikkor Lens
    By pleasecorrupt in forum Photography/Video Equipment and Accessories For Sale
    Replies: 5
    Last Post: 09-29-2011, 12:21 PM
  4. New Headlight Lenses for xenons
    By vwpowa in forum Lighting
    Replies: 21
    Last Post: 06-30-2011, 05:04 PM
  5. Cleaned my headlight lenses
    By tripod06 in forum General -- ZHP Related
    Replies: 22
    Last Post: 03-22-2011, 03:32 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •