Messaggero
All:
I will be replacing my front sway bar end links with LEMFORDER end links this Friday. My symptoms are clunking sound from drivers side wheel area on reverse and at low speeds. Looks like a very easy DIY, however, does anyone out there know the torque values for the 16mm end bar link bolts?
Boss
Standby. I'll check the Bentley.
Droid X. Tapatalk. Use it.
-Be yourself; everyone else is already taken.
ZHP Pre-Ride Briefing
2005 ZHP, Alcantara, Silver Cube, Nav, Sharked, BMW Perf Intake, BMW Perf CF Strut Brace, CF Valve/Fuel Rail Covers,
Shadowline Grills, CF Splitters, Fog Light Inserts, Euro-mirrors, CDV Delete, Beisan vanos, GAS DISA, BP Coded
Boss
Stabilizer bar bushings brackets to subframe: 16 ft/lbs
Stabilize bar link to stabilizer bar: 48 ft/lbs
Stabilizer bar link to strut: 48 ft/lbs
Droid X. Tapatalk. Use it.
-Be yourself; everyone else is already taken.
ZHP Pre-Ride Briefing
2005 ZHP, Alcantara, Silver Cube, Nav, Sharked, BMW Perf Intake, BMW Perf CF Strut Brace, CF Valve/Fuel Rail Covers,
Shadowline Grills, CF Splitters, Fog Light Inserts, Euro-mirrors, CDV Delete, Beisan vanos, GAS DISA, BP Coded
Messaggero
Thank You, don't have my Bentley with me. Good stuff.
Messaggero
Would you concur with my diagnosis based on the symtoms?
Boss
Yes. As long as you've eliminated CABs as a suspect.Originally Posted by echo46
Roll slowly forward and then stab the brakes. If you get a clunk, then it might be the CABs.
Droid X. Tapatalk. Use it.
-Be yourself; everyone else is already taken.
ZHP Pre-Ride Briefing
2005 ZHP, Alcantara, Silver Cube, Nav, Sharked, BMW Perf Intake, BMW Perf CF Strut Brace, CF Valve/Fuel Rail Covers,
Shadowline Grills, CF Splitters, Fog Light Inserts, Euro-mirrors, CDV Delete, Beisan vanos, GAS DISA, BP Coded
Messaggero
I replaced the CABs in August with the Meyle HDs. This clunking at low speeds just started around Thanksgiving. I'm just hoping it is not the control arm, but I doubt it.
Capo di tutti capi
I think its CAB's maybe. The end links only transfer weight from one side of cat to other....in turns.
Unless of course you can see they've failed.
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
Capo di tutti capi
Copy
Make sure you have a skinny open ended wrench.
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
Boss
When I've had endlinks fail, it's usually noticeable as a clunking sound when going over bumps as well.
You're CABs shouldn't be shot already unless one was defective.
Droid X. Tapatalk. Use it.
-Be yourself; everyone else is already taken.
ZHP Pre-Ride Briefing
2005 ZHP, Alcantara, Silver Cube, Nav, Sharked, BMW Perf Intake, BMW Perf CF Strut Brace, CF Valve/Fuel Rail Covers,
Shadowline Grills, CF Splitters, Fog Light Inserts, Euro-mirrors, CDV Delete, Beisan vanos, GAS DISA, BP Coded
Posting Permissions
Reply With Quote