2005 330CI Tranny Help!! Which Fluid to use!

[jbehr99]

That realoem diagram means you have a GM unit. You need to check the color label it has on it to make sure you get the right fluid. Here is a chart I found.....

ATF fluid type labels
• Orange . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Dexron III
• Yellow . . . . . . . . . . . . . . . . . . . . . . . . . Texaco ETL 7045E
(BMW p/n 83 22 0 026 922)
• Green . . . . . . . . . . . . . . . . . . . . . . . . . Texaco ETL 8072B
(BMW p/n 83 22 0 024 359)
• Blue . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Esso 71141 LT
(BMW p/n 83 2 29 407 807)

Here is my label, do you think that is blue or green? There is also the P/N on it.

[IMG][/IMG]

[telijah]

That is realllly hard to tell as it is almost turquoise. As mentioned, if you can get to the ID plate, this would be easier.

[Hermes]

Here is my label, do you think that is blue or green? There is also the P/N on it.

according to that part number and what smolck posted then your label is green

[jbehr99]

according to that part number and what smolck posted then your label is green

Yes, I think you are correct as the part numbers correspond.

[jbehr99]

according to that part number and what smolck posted then your label is green

Yes, I should get the metal id plate. It's just I don't have a jack set at the moment and the car is very low to the ground in general.