Materials to Maintain Your ZHP IIIII Hand Protection IIIII Tools to Maintain Your ZHP
Page 1 of 2 12 LastLast
Results 1 to 10 of 11
  1. #1
    Join Date
    Jan 1970
    Location
    Tampa, FL
    Posts
    709

    What's this BMW part?

    A small trim piece on the front fender is popping out a little and I can't get it to go back in flush. It seems like both ends of it are warped. It looks to be held in by some plastic rivet or something like that. I checked realoem, the only diagram I could find with it was here:
    http://www.realoem.com/bmw/showparts...98&hg=41&fg=10
    It's next to the 5 and 3 in the picture. I checked the trim section, but I couldn't find it there. Anyone know the part # for this & the rivets that hold it in?

  2. #2
    Join Date
    Jan 1970
    Location
    Western WI
    Posts
    3,059
    There's like 3 spots that are referenced as 5 & 3 in that pic. Can you be more specific?

  3. #3
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Last edited by danewilson77; 01-07-2011 at 08:51 PM.
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  4. #4
    Join Date
    Jan 1970
    Location
    Tampa, FL
    Posts
    709
    Ah sorry, I didn't see those are all over the place. All the way to the right, in the center, right under where the side marker goes. It isn't actually in the picture, but this is where it would sit:

  5. #5
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Looks like a pocket for the fender.
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  6. #6
    Join Date
    Jan 1970
    Location
    Tampa, FL
    Posts
    709
    The black trim piece here:

  7. #7
    Join Date
    Jan 1970
    Location
    Western WI
    Posts
    3,059
    IIRC, those are just clips behind there. If you remove them, you may be able to fix them...or you may have to drive around for a week with no trim.

  8. #8
    Join Date
    Jan 1970
    Location
    Tampa, FL
    Posts
    709
    I'm not sure if it's the clips because it feels firmly attached, but it seems like the trim piece itself is warped a little on both ends, causing it to stick out.

  9. #9
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    You were looking in the bodywork cat vice the vehicle trim cat...I completely misunderstood your first post.

    http://www.realoem.com/bmw/showparts...65&hg=51&fg=20


    P/N 51138208447

    Available at: http://www.ecstuning.com/Search/51138208447/ES78539/

    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  10. #10
    Join Date
    Jan 1970
    Location
    Tampa, FL
    Posts
    709
    Autozone.com
    That's exactly what I was looking for! Thanks dude. I was looking in vehicle trim, just didn't see that among the 50 some choices in that category.

Page 1 of 2 12 LastLast

Similar Threads

  1. The Mill Part 2 & more
    By 3ZHPGUY in forum ZHP Gallery and Video Section
    Replies: 4
    Last Post: 06-17-2011, 07:11 PM
  2. What's the proper name for this part?
    By Washburn in forum General -- ZHP Related
    Replies: 18
    Last Post: 04-27-2011, 07:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •