So what would you folks recommend when it comes to spacer size with stock 135 wheels? I've heard 10mm front and 12mm rear works out pretty well. Any thoughts?
I've also heard from various Mafiosos that 12 mm front & 10 mm rear works well. I plan to start out trying that then swapping (10 front, 12 rear) if necessary.
Travis | ’04 ZHP sedan 6MT | WeĭssLĭcht AEs | BMW clears | Plasti-Dipped grilles | BMW Perf. intake | TMS Power Pulleys | DIY aux-in | !CDV
Sprint Booster w/Sport button | Mich PS AS4 (245 sq) | M3 front sway | Z4M LCABs | Beisan VANOS rebuild | GAS DISA rebuild | BMW diag. PC
In for results since I am curious.
Also has anybody swapped their zhp from wheel bolts to wheel studs ?
Stupid fast tire changes.
For someone like me, I can change tires in 15 minutes (that includes getting the car in the air, tires out...etc).
With the wheel studs, you can just throw the tire on the studs, get one nut on the car. Once that one nut on the car, the whole wheel centers and you can zip through the other 4.
Project STX: TCKline Racing l APEX l Vorshlag l Eibach l Hawk l Schroth l BMW Performance
10F/12R for me. Doesn't seem too bad. I plan on trying 12F/15R in the spring if I don't get new wheels
I run 12F/15R and I think it is about perfect. I don't know your suspension setup, but if you're on stock it should be fine.
I would go with TMS spacers, that way you can get the black lugs.
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim