How tough are the needle removal and replacements?
2004 BMW 330CI ZHP, Silver Grey Metallic, Dinan: Stage 2 Software, High Flow Intake,
Free Flow Exhaust, Front Strut Bar, Stage 2 Suspension System, Staggered Hartge Replica Wheels,
M3 Mirrors (Side and Interior), M3 Seats
That's the thing, I didn't want to mess with it since you never get it aligned properly. That is why if you look closely, you can see a little slit on the speedo so I can get it over the needle without taking it off.
FWIW removal isn't that difficult, you just have to be careful not to scratch the face when you pry it off
I didn't think it's difficult to remove the needles. It just twists off. Why does everyone use a fork? lol
Emma - 2005 BMW 330ci ZHP 6MT Estorilblau Individual
Sportline 8s 18x8.5F - 18x9.5R | APEX ARC-8 18x8.5 Square | aFe Intake | 135i Brembo F/R Calipers | 26mm Front/20mm Rear Sway Bars | Z4 Mirror
M3 Dead Pedal | Lexus ES300 Yellow Fog Light Retrofit | Koni Yellows/H&R Springs | Llumar CTX 40% | Coby Tri-Stitch Wheel & Boots
Awaiting Install: M3 Wing Mirrors
You supposed to just rotate it CCW while gently pulling on it. After like 2 rotations it comes off. Then to align, you just put the needle back on and just rotate it to where it bottoms out again. then push keep pushing it to where you want it to be. Do it gently without the fork lol