Materials to Maintain Your ZHP IIIII Hand Protection IIIII Tools to Maintain Your ZHP
Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: Clock dont work

  1. #1
    Join Date
    Dec 2012
    Location
    Palm Beach County, FL
    Posts
    397

    Clock dont work

    When I press and toggle that little knob thingie next to the tach, the clock dont set/reset/nothing... any suggestions? Its off by like 50 minutes.
    __________________________________________________ ____
    2003 ZHP 4dr | 145,000 miles (ACTUAL before RIP) | BBS 17"
    Hankook Ventus V12
    Front: 225/45ZR
    Rear: 255/40ZR-17 Hankook Ventus V12 evo2 XL
    [ Staggered on square (17x8.5 +38) ]

  2. #2
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    You need to gently tuuuuuuuurn it. Not press it. Again......gently.
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  3. #3
    Join Date
    Dec 2012
    Location
    Palm Beach County, FL
    Posts
    397
    I'm pretty sure I did that... I dont think I yanked it, sorry I remember now... but I'll try to do it more slowly and in subtle fashion and report back.
    __________________________________________________ ____
    2003 ZHP 4dr | 145,000 miles (ACTUAL before RIP) | BBS 17"
    Hankook Ventus V12
    Front: 225/45ZR
    Rear: 255/40ZR-17 Hankook Ventus V12 evo2 XL
    [ Staggered on square (17x8.5 +38) ]

  4. #4
    Join Date
    Jun 2011
    Location
    Redondo Beach, CA
    Posts
    1,944
    Not sure if you're looking at the clock on the radio display and trying to change it but you have to cycle the BC button until the time is displayed in the center of the instrument cluster and then turn the little knob on the right near the water temp gauge.
    2006 CiC 6MT
    ZHP, Cold Weather, Xenon
    Sapphire Black / Black Leather / Black Cube

  5. #5
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Quote Originally Posted by wsmeyer View Post
    Not sure if you're looking at the clock on the radio display and trying to change it but you have to cycle the BC button until the time is displayed in the center of the instrument cluster and then turn the little knob on the right near the water temp gauge.
    Yep. Great thinking.

    Sent from the HTC DNA, Williamsburg, VA and USA
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

  6. #6
    Join Date
    Dec 2012
    Location
    Palm Beach County, FL
    Posts
    397
    Yes clock on the radio display.... whats the BC button? But I think I am doing what u are referring, I make sure the time is on the radio display fully before the turn the knob, not sure how else I would know the clock is being adjusted?
    __________________________________________________ ____
    2003 ZHP 4dr | 145,000 miles (ACTUAL before RIP) | BBS 17"
    Hankook Ventus V12
    Front: 225/45ZR
    Rear: 255/40ZR-17 Hankook Ventus V12 evo2 XL
    [ Staggered on square (17x8.5 +38) ]

  7. #7
    Join Date
    Jun 2011
    Location
    Redondo Beach, CA
    Posts
    1,944
    Quote Originally Posted by Dathaeus View Post
    Yes clock on the radio display.... whats the BC button? But I think I am doing what u are referring, I make sure the time is on the radio display fully before the turn the knob, not sure how else I would know the clock is being adjusted?
    On the end of your turn signal lever there is a button that says BC> pushing it cycles what is displayed in the center of the instrument cluster. With the ignition on push it until the clock is displayed and then you can adjust it.
    2006 CiC 6MT
    ZHP, Cold Weather, Xenon
    Sapphire Black / Black Leather / Black Cube

  8. #8
    Join Date
    Apr 2012
    Location
    Hereford, AZ
    Posts
    1,081

    '21 M2 Competition
    '08 Z4 M Coupé
    '19 Golf R

  9. #9
    Join Date
    Jun 2012
    Location
    Montreal, Canada
    Posts
    1,939
    ^LOL
    Alex'16 Melbourne Red 328d Touring
    M Sport + M Performance Package

    Gone, but not forgotten: '03 Imola Red 330i ZHP - 6MT


  10. #10
    Join Date
    Jan 1970
    Location
    Liberty Township, OH
    Posts
    37,935
    Quote Originally Posted by Dathaeus View Post
    Yes clock on the radio display.... whats the BC button? But I think I am doing what u are referring, I make sure the time is on the radio display fully before the turn the knob, not sure how else I would know the clock is being adjusted?
    NO.

    Make sure he clock is displayed on the instrument cluster, by using the button (push in) on the end of your "blinker stalk".

    Then set the time with the knob you were referring to.
    Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim

Page 1 of 2 12 LastLast

Similar Threads

  1. 2nd ZHP? Do or dont?
    By 09mageec in forum General -- ZHP Related
    Replies: 37
    Last Post: 04-17-2012, 04:48 AM
  2. How do I change the time on the clock?!
    By antcamp in forum General -- ZHP Related
    Replies: 14
    Last Post: 11-14-2011, 06:47 PM
  3. MT work?
    By Scorpius in forum Maintenance
    Replies: 27
    Last Post: 11-08-2011, 10:41 AM
  4. Dont Do Dat...
    By danewilson77 in forum ZHP Gallery and Video Section
    Replies: 11
    Last Post: 12-19-2010, 07:52 PM
  5. Replies: 12
    Last Post: 11-26-2010, 06:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •