Proper placement of rear decklid spoiler

[2004_blue_zhp]

Can anyone point me to either photographs or technical drawings indicating the correct placement/alignment of the rear decklid spoiler on a ZHP coupe?

In particular, regarding left-to-right placement, how much space should there be between the left(right) edge of the spoiler and the left(right) edge of the decklid itself?

And separately, regarding front-to-back placement, how much space should there be between the beginning of the bevel at the rear end of the decklid and the base of the spoiler itself?

Thanks!

[ELCID86]

---
"ZHP is a garbage option anyway- just some cosmetic upgrades with a different cam and diff to claw back some of the performance lost fitting those hideous and heavy wheels. Any 330 with a 3.46 diff will smoke a ZHP every time. The whole Mafia thing reeks of childish behavior." - anonymous

[2004_blue_zhp]

This is, in a nutshell, why this community is the best one out there.

Thanks so much for the spot-on answer, ELCID!

[ELCID86]

NP. Hope it helped.


---
"ZHP is a garbage option anyway- just some cosmetic upgrades with a different cam and diff to claw back some of the performance lost fitting those hideous and heavy wheels. Any 330 with a 3.46 diff will smoke a ZHP every time. The whole Mafia thing reeks of childish behavior." - anonymous

[Oli77]

Nothing like centimeters when you need precision ��

[ELCID86]

Yeah the good ole Amerikan inch comes up a bit short sometimes;-)


---
"ZHP is a garbage option anyway- just some cosmetic upgrades with a different cam and diff to claw back some of the performance lost fitting those hideous and heavy wheels. Any 330 with a 3.46 diff will smoke a ZHP every time. The whole Mafia thing reeks of childish behavior." - anonymous

[BMWCurves]

32mm or 0.0174978 fathoms, whichever you find easier

[GotZHP]

Inches are good for construction and carpentry only ive found. anything related to machining and auto, gotta go metric

I can take some photos of my trunk lid tmrw if you want another set for reference

[BMWCurves]

Inches are good for construction and carpentry only ive found. anything related to machining and auto, gotta go metric

I can take some photos of my trunk lid tmrw if you want another set for reference

+1 I can do the same since you (2004_blue_zhp) and I both have coupes and there might be some slight differences between coupes and sedans.

[2004_blue_zhp]

Curves, that's a generous offer. I'll bet this could be a nice permanent reference if you followed through!