Understeer SSK...

[Zaks]

To make a long story short, I installed it yesterday with new uuc mounts and mount enforcers. Selector rod is rubbing the driveshaft when driving. I took off the enforcers and it still rubs, so I'm wondering if anyone here has done this kit and what is the solution.

Next step is to install the stock lever (SSK came with the MZ3 lever) and see if the problem goes away. If it does, I was thinking of shaving the edge of the selector rod, but open to advice.

Thanks in advance, spending 9 hours under my car last 2 days was not fun!

[BMWCurves]

The SSR rubs against the driveshaft? I had this issue. They sent me the wrong part, even though it was labeled as the correct part. Had to repeatedly call them to finally admit they might have sent me the wrong part.

[Zaks]

The SSR rubs against the driveshaft? I had this issue. They sent me the wrong part, even though it was labeled as the correct part. Had to repeatedly call them to finally admit they might have sent me the wrong part.

Not their SSR, but my stock selector rod with the MZ3 lever installed. I'll check the lever part # tomorrow as I think there may be an even longer one than MZ3 that would make it rub for sure.