You don't need to bake the headlights to change the bulbs - they are accessible through the backside.Quote:
Originally Posted by san
Printable View
You don't need to bake the headlights to change the bulbs - they are accessible through the backside.Quote:
Originally Posted by san
Oh I did not know that, Thanks!Quote:
Originally Posted by az3579
Sent from my iPhone using Tapatalk
For the turn signal bulbs at least, it's best to remove the headlight assembly. Not sure if the same applies to the low/high beam and DRL/FTP bulbsQuote:
Originally Posted by san
Yep, either that, remove the air cleaner & washer tank, or REALLY small hands........Quote:
Originally Posted by BMWCurves
I'd go with the route of least resistance... removing the washer tank and air filter housing are both trivial tasks. Might as well!Quote:
Originally Posted by fw_fw
Guy,
Do you have the capability of fixing a crossthreaded bolt? I can't secure my center console due to the bolt being crossthreaded, so I fear I may need to tap it out with a larger bolt. I don't have the tools or know-how... do you?
I have the know how but, not the tools! [emoji15]Quote:
Originally Posted by az3579
Sent from my iPhone using Tapatalk
I think I have the tools to help, let me see. Will report back tomorrow.
Thanks John.Quote:
Originally Posted by Johnmadd
Sent from my VS990 using Tapatalk
You da man!Quote:
Originally Posted by Johnmadd
I looked up Lowes/Home Depot near Guy's address and there's a Lowes about 20 minutes from there. Hopefully we can find a suitable bolt to replace the old one... not sure what the factory thread is, but the head is 13mm.