ZKW to AL Swap: Mounting Bracket?

Quote:

---

Originally Posted by danewilson77

http://i1015.photobucket.com/albums/...idebefore1.jpg

http://i1015.photobucket.com/albums/...rsideafter.jpg

http://i1015.photobucket.com/albums/...sidebefore.jpg

http://i1015.photobucket.com/albums/...c/IMAG2189.jpg

http://i1015.photobucket.com/albums/...comparison.jpg

Sent from my Samsung Galaxy S4

---

Bumping the thread.

I just did this on my ZSP I just bought. Thanks for posting the pics.

Quote:

---

Originally Posted by stephenkirsh

Bumping the thread.

I just did this on my ZSP I just bought. Thanks for posting the pics.

---

Did the ZSP originally have halogens or ZKW Xenons? I've never seen ZKW Xenons on a non-ZHP before, so I'm trying to figure out if my theory is correct.

Quote:

---

Originally Posted by az3579

Did the ZSP originally have halogens or ZKW Xenons? I've never seen ZKW Xenons on a non-ZHP before, so I'm trying to figure out if my theory is correct.

---

It had zkw xenons from factory.

I’m gunna try and rebuild them and put them on my halogen ZHP. Has anybody done that?

Zkw on top.

Attachment 34140

Quote:

---

Originally Posted by danewilson77

Just cut it with a Dremel.

Sent from my Samsung Galaxy S4

---

Well, I guess I made the right choice. I just posted a thread about my effort swapping a MM/AL assembly with my ZKW and I eventually figured out I needed to dremel out the ZKW mounting bracket that went around the headlight washers.

Glad I made the right decision.

However (and I have not gotten to the end of this thread) I still had a "gap" on the outside part of the MM/AL assembly there it abuts the turn signal. I could not figure out how to close that gap.