F10 M5 Shift Knob - Installation
Thank you to Raymond Lee for my 8 month belated birthday present.
I installed the new shift knob today with the old boot. I am not a fan of the leather boot plus it does not really go well with the rest of the alcantara set up in the car. Overall I am really satisfied with the way things turned out.
So let's begin with the write up.
The first step I tried was using a heat gun and heating up the middle ring while pushing down the leather inside out. Causing the glue to melt a little and giving me more room to work with. Then I press on the tab on the left and it release the ring from that side. The other two tabs are larger and I just ended up breaking them off. Pretty much the ring is used to keep the cloth from dropping too low from the shift knob itself. I did not reattach the ring to the knob. I will see how it works over the next week or two before I add a cable tie or something to hold it in place.
http://i.imgur.com/tB7poBC.jpg
http://i.imgur.com/h53i6Es.jpg
I made two snips into the leather boot to remove the wiring from the shift boot.
http://i.imgur.com/wdoGjXT.jpg
Followed by snipping the plastic on the right from the ash tray holder wires.
http://i.imgur.com/bkOuhXx.jpg
Reinstalled everything
http://i.imgur.com/jU2rNM5.jpg
I will have some photos once it gets dark. Along with my feeling/opinions towards this knob and lighting.
All photos are here - http://imgur.com/a/mjGTR#0