forget the insulation. i'm going to pin up a nomex suit to the underside of the hood.
Printable View
forget the insulation. i'm going to pin up a nomex suit to the underside of the hood.
Mine stays in place, but the front driver's side tab has "shrunk" to the point where it won't stay in the hood slot. Even at $88 it's hard to justify replacing it when it looks great otherwise. Perhaps a strip of double-sided tape or Velcro will remedy the situation.
My problem is I tried to stretch the tabs a bit and tore a hole. :facepalm Tape works for a while, but it's still annoying having the powder come out.
Noise diagnosis: Backing out of the driveway this morning I heard a single click/pop as I turned the wheel. Each of the 4 righthand turns between the house and office were also accompanied by a single pop. (Edit: it does not make this sound when turning left).
I'm going to check the end links during lunch, but what are my other possible culprits? CV? I have tie rods waiting to go in, as I'm trying to resolve some wheel vibration at 50mph+. Any advice is welcome. Thanks, gentlemen.
did you install those front konis yet?
sounds like a ball joint or tie rod end. both are original as they were in good shape at that point. it's not going to be a CV as your car is RWD. ;)
i replaced the end links and FCABs last summer - doubtful that the FCABs are the issue, as that's not a symptom of FCAB failure... wheel jerk under light braking is the dead giveaway.