What did you do for your ZHP/BMW today?

Quote:

---

Originally Posted by SkiB97

I did a lot of more work on my ZHP in the past two weeks than I was hoping for. What started as a simple Turbo kit installation instead turned out to be maintenance job from hell.
During the process of gear box removal I busted (broken off) both 12mm gearbox/engine mounts of the engine block. Bolts were over toques and appeared corroded on the end so it would not pull through the tread and busted both off. Had to remove the engine block to have them welded back on. After a few days delay for block repair I replaced the clutch disk (Kevlar) M3 pressure plate and M3 throw out bearing. Lastly I installed Technique Tuning turbo kit. That was the easy part compare to the rest. Running at 6 psi now until I install the EBC sometime after I recuperate from this last fiasco and enjoy this car a little.

---

I don't see your name on the list, Darius, of those attending the Virginia meet in a few days. We won't see you there? Would love to check out your car.

Taped off and sprayed lower grille flat black, also touched up a few rock chips in the M-Technic bumper! Grille looks awesome, nice and dark now to match the kidneys.

Quote:

---

Originally Posted by CERF04ZHP

Taped off and sprayed lower grille flat black, also touched up a few rock chips in the M-Technic bumper! Grille looks awesome, nice and dark now to match the kidneys.

---

Very good sir.

Droid + Tapatalk = FTW!

Took off that tiny little clip thing on the driver's side wiper blade. It's where the spring is. Just push it forward towards the passenger wiper blade and it pops right off. Only do this if you have bracketless wiper blades (i.e. RainX or Bosch Icons). It'll stop the chattering/skipping, but it may make your non-bracketless wiper blades not work if you don't have those.

Let my mom drive it because she was getting her inspection I done. I'm scared that she'll come back with a cracked splitter :eeps

Quote:

---

Originally Posted by lilcdkey

Let my mom drive it because she was getting her inspection I done. I'm scared that she'll come back with a cracked splitter :eeps

---

Just tell her to roll slow, and low...like a turtle.

Droid + Tapatalk = FTW!

It came back unharmed :biggrin

Yesterday (meant to post yesterday but was tired), I introduced some darkness to the environment:

http://i200.photobucket.com/albums/a...-16-58_568.jpg

http://i200.photobucket.com/albums/a...-17-07_593.jpg

http://i200.photobucket.com/albums/a...-19-16_226.jpg

Quote:

---

Originally Posted by az3579

Yesterday (meant to post yesterday but was tired), I introduced some darkness to the environment:

http://i200.photobucket.com/albums/a...-16-58_568.jpg

http://i200.photobucket.com/albums/a...-17-07_593.jpg

http://i200.photobucket.com/albums/a...-19-16_226.jpg

---

The black corners look really good on that Imola red. I'm deciding if I'm going to put smoked corners or clear corners on my jet black ZHP.

Quote:

---

Originally Posted by Newjack

The black corners look really good on that Imola red. I'm deciding if I'm going to put smoked corners or clear corners on my jet black ZHP.

---

On a Jet Black, I would put ambers or clears. I'd prefer ambers more, personally, as I've always loved orange and black combos.