Thanks fredo [emoji1417]Quote:
Originally Posted by fredo
Sent from my iPhone 11 Pro Max using Tapatalk Pro
Printable View
Thanks fredo [emoji1417]Quote:
Originally Posted by fredo
Sent from my iPhone 11 Pro Max using Tapatalk Pro
Today ended up being an amazing day so I took some time to finish off a recent retrofit. It came down to a 30A fuse in my fuse panel so I replaced it. Everything checked out and I turned my car on, pressed my rear sunshade button and watched everything work as if it was originally installed. Very satisfying to see this rare option installed on my ZHP working like it should [emoji41]
https://uploads.tapatalk-cdn.com/202...9ab897888f.jpg
https://uploads.tapatalk-cdn.com/202...b619432c9b.jpg
https://uploads.tapatalk-cdn.com/202...972b07f9c4.jpg
https://uploads.tapatalk-cdn.com/202...6dea3d1e82.jpg
This retrofit was not too difficult to install. For me making up the long wiring harness then using BMW cloth tape to wrap it up was the hardest part of this retrofit[emoji4]
https://vimeo.com/710572204
Sent from my iPhone 11 Pro Max using Tapatalk Pro
looking good charlie!
Thanks Daniel! :thumbsupQuote:
Originally Posted by kakashi169
https://uploads.tapatalk-cdn.com/202...a8bf312ff7.jpg
I can't say enough for this product when cleaning my alcantara steering wheel[emoji41] It just works[emoji16]
https://uploads.tapatalk-cdn.com/202...9972b0ba0f.jpg
there was enough dirt still left on my steering wheel so I lathered up the steering wheel in sections and used clean fresh microfiber cloth, orange in this case, to wipe off the solution. as you can see it took off the dirt from my steering wheel[emoji41]
https://uploads.tapatalk-cdn.com/202...5f7f7336bc.jpg
my steering wheel is now clean ready to install once it dries up[emoji1417]
Sent from my iPhone 11 Pro Max using Tapatalk Pro
Sonax is such a good product
:thumbsupQuote:
Originally Posted by BADCLOWN
It's raining today so I'm prepping one of my OEM M3 mirror base plates to get it trimmed up for sedan fitment [emoji41]
https://live.staticflickr.com/65535/...d1d9b385_b.jpg
Per Rogue Engineering DIY you leave 1/8" exposed on the posts to trim off.
https://uploads.tapatalk-cdn.com/202...a7808baf29.jpg
Next on the longest part of the baseplate You mark off 5/32" at the bottom and mark off 1/8" at the top then tape off that edge trying to follow the curvature of the baseplate as best as you can.
https://live.staticflickr.com/65535/...21db5999_b.jpg
The last part in taping off the mirror baseplate for sedan fitment is the upper back part of the baseplate where my finger is pointing to . . .
https://uploads.tapatalk-cdn.com/202...98af874880.jpg
For this part you start 2.9" from the top and line the tape from the edge at that point to the 1/8" point on the top then you're done marking everything off [emoji1417]
https://live.staticflickr.com/65535/...cfe225aa_b.jpg
It should look like this.
https://uploads.tapatalk-cdn.com/202...3ea4a0b3bd.jpg
Now you're ready to trim your baseplate[emoji41]
I also updated my M3 side mirror retrofit DIY . . .
Sent from my iPhone 11 Pro Max using Tapatalk Pro
good work charlie! always very informative
Appreciate the feedback on my work Daniel, thanks!! :thumbsupQuote:
Originally Posted by kakashi169