LED Lights and More!

[UdubBadger]

nice, I love the LED tails

[Hochspannung]

Thanks guys, I'm super happy with the new changes

[Newjack]

Not needed for the interior bulbs.

Droid X. Tapatalk. Use it.

Thanks Kayger, thats what I thought. The only use for the resistor I could think of would be for the license plate lights. But I don't think there is a BOW for those anyways.

[iZHP]

I have to say though that the depo side markers gave me a bit of a headache. The spring tab that holds the marker in place popped off while inserting the light and fell inside my fender. I was able to grab it with a magnetic screwdriver through the door jam. But then it popped off again and was lost. This happened on BOTH sides on the first try. I had to remove the tab from the stock markers and glue them into the depo markers because they were a bit different and they don't snap in. After that they installed easily, but I was a bit frustrated after that. The tabs on the depo lights are on a more obtuse angle and require more space to bend. Bottom line. I hate those tabs.

+1 This happened to me too! One side is just hangin in there...and they're already chipping around the edges...that's what you get with aftermarket quality I guess.

[kayger12]

Thanks Kayger, thats what I thought. The only use for the resistor I could think of would be for the license plate lights. But I don't think there is a BOW for those anyways.

Welcome. Fwiw, I put Khoa's LEDs in for the license plate lights as well and got no BOWs. I wasn't sure whether there was a BOW for those, either, but they've been in for several months and they're fine.

[Hochspannung]

Ok well.. I just went to grab my gym bag from my trunk and my plate lights stayed on, this was a few minutes after I had turned the car off. They are off now, I've been home for ten minutes. Duno if I should get resistors or not? I assume its just using up some stored up voltage left from when the car was running then it runs out and they turn off. Or can this drain the battery somehow?

[Hochspannung]

Also! I installed the 7500k 9006 halogens in my fogs today. They look pretty pretty pretttttyyyy good lol

BEFORE


AFTER

[jayjay_dee]

Looking good!!!

I too have Khoalty's LED interior set, and they are awesome...

[iZHP]

Installed LED DRL's today. I like them, but I have to get used to it. Flash to pass works, and they function as high beams as well (obviously not much light output though).

[Hochspannung]

that looks pretty sweet. I didn't that was an option.