Materials to Maintain Your ZHP IIIII Hand Protection IIIII Tools to Maintain Your ZHP
Amazon Link for ZHPMafia ZHP
Amazon Link for ZHPMafia ZHP
Amazon Link for ZHPMafia ZHP
Page 216 of 1008 FirstFirst ... 116166206214215216217218226266316716 ... LastLast
Results 2,151 to 2,160 of 10072
  1. #2151
    Join Date
    May 2011
    Location
    Kansas City
    Posts
    1,328
    Ya got an air leak somewhere get some brakleen with ether in it (green can) and spray around the intake parts you just worked on... listen for idle fluctuations if ya can get an idle flucuation to repeat when spraying in a particular area, you have found the leak

    Mods: Smoked corners, smoked side markers, smoked tails, 35% tint, CF kidney grills, debadged, angel eyes, 3000k HID Fogs, OBX exhaust, Sharked, solo werks S1 coilovers, front and rear strut brace, AUX cable
    "I'd rather lose by a mile because I built my own car, than win by an inch because someone built it for me"

  2. #2152
    Join Date
    May 2011
    Location
    Kansas City
    Posts
    1,328
    ya got an air leak somewhere. Get some Brakleen with ether in it (green can) and spray it around the area you just worked on. if you can get an idle fluctuation to repeat while spraying a particular area you have found the leak

    Mods: Smoked corners, smoked side markers, smoked tails, 35% tint, CF kidney grills, debadged, angel eyes, 3000k HID Fogs, OBX exhaust, Sharked, solo werks S1 coilovers, front and rear strut brace, AUX cable
    "I'd rather lose by a mile because I built my own car, than win by an inch because someone built it for me"

  3. #2153

  4. #2154
    Join Date
    Aug 2011
    Location
    San Ramon, Calif. Bay Area
    Posts
    1,190
    Ordered 2 rear tires for the X5....$$$$, ordered Perfromance intake for ZHP picked up AE V2, HID Fogs, hope to install on Monday

  5. #2155
    Join Date
    May 2011
    Location
    Kansas City
    Posts
    1,328
    Quote Originally Posted by cakM3 View Post
    I cleaned and polished the ZHP and installed my Aux input
    How invasive was the AUX input install? been wanting to do this

    Mods: Smoked corners, smoked side markers, smoked tails, 35% tint, CF kidney grills, debadged, angel eyes, 3000k HID Fogs, OBX exhaust, Sharked, solo werks S1 coilovers, front and rear strut brace, AUX cable
    "I'd rather lose by a mile because I built my own car, than win by an inch because someone built it for me"

  6. #2156
    Used the 3M Headlight Restoration Kit. It works wonders! $13 off of eBay. Due to the curves on our car and how the headlights are placed relative to the hood and body panels, it is somewhat difficult to restore them, especially with a coupe.

    Now, when you do this, painter's tape the hell out of everything around the headlights, and I mean tape the hell out of it. It's going to be near-impossible not to get a few nicks in corners by the headlights, but you will not be able to see them at all.

    Use 3-4 layers of tape, shoot even 5, all around the headlight and the top of the bumper. I did not do it on the top of the bumper for one headlight and found out the hard way. Some clear coat fixed those scratches right up.

  7. #2157
    Quote Originally Posted by midlandtech View Post
    How invasive was the AUX input install? been wanting to do this
    All I had to do was take out the trim pieces then pull the center vent out. The Aux input cable was tied to a bunch of cables to the left wrapped on top. All I did was undo the wrap to free the connector and then connect my Aux input cable from the kit. Very easy.

  8. #2158
    Join Date
    Jan 1970
    Location
    Cleveland/Dayton
    Posts
    2,620
    Put snow tires on the Scion, put snows on the dad's e92, put my car to sleep



    Shot of the whole gang





    Sent from my DROID X2 using Tapatalk


    Project STX: TCKline Racing l APEX l Vorshlag l Eibach l Hawk l Schroth l BMW Performance

  9. #2159
    nike001 Guest
    What do you drive in the winter, Kyle? The Scion?


    My thread contribution: I was just outside trying to adjust my lights. I can't get them aimed directly ahead. I once made a mistake when trying to change my clears, that I was screwing the horizontal adjuster on my lights instead of the actual corner light thing. Ever since then, I can't get them right. Gets me so mad!

  10. #2160
    Join Date
    Jan 1970
    Location
    Cleveland/Dayton
    Posts
    2,620
    Quote Originally Posted by nike001 View Post
    What do you drive in the winter, Kyle? The Scion?


    My thread contribution: I was just outside trying to adjust my lights. I can't get them aimed directly ahead. I once made a mistake when trying to change my clears, that I was screwing the horizontal adjuster on my lights instead of the actual corner light thing. Ever since then, I can't get them right. Gets me so mad!
    Yea, the tC is my school and winter car.

    For your headlights, just look up the specs on how to measure it up against a wall...then go the 25 feet away or so, tape it up and mark it!

    Sent from my DROID X2 using Tapatalk


    Project STX: TCKline Racing l APEX l Vorshlag l Eibach l Hawk l Schroth l BMW Performance

Page 216 of 1008 FirstFirst ... 116166206214215216217218226266316716 ... LastLast

Similar Threads

  1. Got a few shots of her today
    By static667 in forum ZHP Gallery and Video Section
    Replies: 10
    Last Post: 05-01-2011, 09:16 AM
  2. I learned something today...
    By otto99 in forum General -- ZHP Related
    Replies: 3
    Last Post: 03-29-2011, 09:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •