Let me srsly think about this before I commit. Thanks for the offer.
Let me srsly think about this before I commit. Thanks for the offer.
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
No problem, and I can always answer questions for you if needed while you are doing it.
It seems like a lot of work and is outside my technical knowledge. Darn; was thinking *maybe* it would be a DIY project for me...
You're saying there are issues with alignment and getting the projector to sit right. I'm not creative enough to do that. lol
There are smaller and easier to mount projectors that they have but the light output and spread is not going to compare to the fxr. The fxr is actually a pretty good fit for our frames.
I just confirmed the badge of shame on my headlights. Someone replaced both covers with AL, but the headlights are in fact zkw. This explains the extremely poor light output. Now, what to do about it...
That sucks. And an incredibly pre-meditated douche bag move on the part of whoever did it.
-Be yourself; everyone else is already taken.
ZHP Pre-Ride Briefing
2005 ZHP, Alcantara, Silver Cube, Nav, Sharked, BMW Perf Intake, BMW Perf CF Strut Brace, CF Valve/Fuel Rail Covers,
Shadowline Grills, CF Splitters, Fog Light Inserts, Euro-mirrors, CDV Delete, Beisan vanos, GAS DISA, BP Coded
if the problem is due to the projector bowls "burning out," and that's most likely the problem. the best option seems to be a projector retrofit from a place like lightwerkz. a fellow ZHP owner, and good friend, had this same problem on his '04 ZHP.
sent his lights to lightwerkz and had the upgrade performed - very happy with the service and results. I can't believe how nice his lights are now.
I'm now contemplating something similar to upgrade my stock halogens.
- now with 5 speeds
I'd love to, but I need these headlights on my car on a daily basis. I also had trouble getting them out. I need the entire housing to come out, and I see 2 8mm bolts on the top, but there's something holding it on underneath that I can't get to. How do you get the housing out?
The lenses are interchangeable, but for some reason the zkw ones are more expensive. ?????