What did you do for your ZHP/ BMW / MINI today? #2

[az3579]

I'm super excited to hang out and play with a car for the day!

Fixed. =\

You can't play with (my) Impala!!!!

[JupiterBMW]

Fixed. =\

Ah ok, so no coding on the X3 then, eh? No worries...

[az3579]

Ah ok, so no coding on the X3 then, eh? No worries...

I got nothin' for ya... it was too short notice.

[JupiterBMW]

I got nothin' for ya... it was too short notice.

No worries buddy! We'll have plenty else to do... Power tools will be in use!

[az3579]

No worries buddy! We'll have plenty else to do... Power tools will be in use!

I hope you didn't plan on coding with power tools... unless you believe hammers fix computers!

[Johnmadd]

[Tnhl1989]

BP plasti dip imola onto Jon's car :P

[Stu]

My driver's side fender corner light just magically stopped working in front of me after I locked my car. I took it off, plugged the passenger side side in to confirm the wiring is good, then plugged the driver's side corner light back on, and now it's working again.

BTW, don't remove without a non-marring pry tool. It will make removal seconds long without worrying about paint scratches.

I found a small rust spot on my passenger-side door jamb from what I would imagine was the seatbelt hitting the door at one point in its life. It's not any bigger than, say, the tip of a dull pencil. I figure I'll get it taken care of some time later. Shouldn't be a bad repair. I put some clear coat over it in an attempt to slow it down or something, but it's so small I am not too worried about immediate problems. It'll be taken care of before this winter.

[gr330zhp]

Oh the joys of 7 Series power steering lines


Sent from my iPhone 5.

[JupiterBMW]

Well, I managed to get a couple things done tonight... The box from TMS included an OEM ///M dead pedal, which was installed this evening. In addition, I installed the CF diffuser that arrived while I was in Texas...

Tomorrow, the car goes up on jacks and BP and I will get my Dinan muffler on (power tools go HERE...) as well as the final installation of my CF splitters...

Pictures coming soon... My county received 9 inches of rain this afternoon, so I don't exactly have good weather to clean the car and take shots.