How long do you guys let your cars idle in the morning? Chicago weather is dropping temp and I’m just wondering if I’m helping or doing more harm by letting it idle for 5mins or so. I’d always thought that it helps bring everything up to temp, but I’ve been wrong before
Sent from my iPhone using Tapatalk
2004 BMW 330i TiAg ZHP/// 6MT(purchased from forum 6/06/16);
KONI Yellows | Akebono Brake Pads | ECIS cold air intake system;
Hotchkis Sport sway bar | ECS Tuning Carbon Fiber front strut brace
Vibrant Performance Muffler | Coby Wheel Tri-Stitch steering wheel & shift boot
Michelin PSS | Blizzak WS-80
Thanks so much guys, that’s what I was beginning to figure out, good to have some other input than my brothers dismissive mechanic talk(“yea it can do damage but it’s whatever”)
Sent from my iPhone using Tapatalk
2004 BMW 330i TiAg ZHP/// 6MT(purchased from forum 6/06/16);
KONI Yellows | Akebono Brake Pads | ECIS cold air intake system;
Hotchkis Sport sway bar | ECS Tuning Carbon Fiber front strut brace
Vibrant Performance Muffler | Coby Wheel Tri-Stitch steering wheel & shift boot
Michelin PSS | Blizzak WS-80
Call Me Dane l 2/2004 330i ZHP l 18x8 ET45 BBS CK's wrapped with Michelin Pilot Sport AS3+ @ 245-40-18 l KW V1 Coilovers in front l KW V1 springs w/ Bilstein B8 dampeners in rear l BMW Performance Rotors l UUC StrutBarbarian l Racing Dynamics Rear Strut Bar l Jim Conforti Shark Injector l Light Birch Interior Trim l Bimmian Celly Mount l M3 Trunk Mat l l e90 Performance E-Brake & Shift Knob l M3 Tri-Stitched Boots l AL Headlight Retrofit with ZKW Lenses l CobyWheel Wrap w/M3 Stitching l LCM sw 4.5 triple blink and rear fogs l Maple Interior Trim
I only idle mine for a few seconds and then drive it gently until it reaches normal temperature but, for example, my wife likes to remote start her car ('12 Grand Cherokee) so the interior / seats warm up so involuntarily the engine is probably getting unnecessary wear.
The little HK speaker cover on the door had some sort of residue on it which I tried to wipe down. I think it exposed the metal. Is this cover replaceable, or how would I go about trying to paint it?