I. Assemble tools

A. Electrical Connector set. I already had this.....and it had the appropriate connector.

B. Some to cut and strip wire. I used a combination of wire cutters and pocket knife.

C. Small tweaker.





II. Remove old ground wire by slowly "tweaking" out on clip, and pulling wire out simultaneously. Mine came right out. You can see where the plastic was melting and where the brown wire is starting to char.



III. Cut off old connector and strip back to where good wire exists.

IV. Install new ground connector. I ended up using the blue one.

V. Plug into lug on circuit board. Red "Dot" below



VI. Plug main connector back in, and your all done.