The Random E46/ZHP Question Thread

[BMWCurves]

Good luck, let us know how it works out.

[sillieidiot]

i don't have any broken pins, but on my friends car which I fixed for him. I just used jb weld. now it's on there hard as a rock lol

[smacame]

The Sikaflex treatment worked well. JB weld would also be good. The plastic doesn't seem to be too difficult to bond to.

[Ssparrow]

So my drivers side seat has some cracks beginning to develop on the bottom part of the seat. Are there any products out there that can repair the cracks? I'd like to do it as soon as possible so they don't get any worse. Grey leather btw.

[az3579]

So my drivers side seat has some cracks beginning to develop on the bottom part of the seat. Are there any products out there that can repair the cracks? I'd like to do it as soon as possible so they don't get any worse. Grey leather btw.

The best you can do is treat it regularly with Leatherique Rejuvenator and Pristine Clean. If you have some miles on your vehicle, I'd recommend replacing your seat cushion foam as well so the leather has fresh foam to stay tightly wrapped against. Deteriorating foam is one of the causes of cracks in the leather. When it wears, the leather doesn't stay as tight anymore and ends up folding. The repeated pressure of sitting on folded leather eventually makes it crack. Leather dehydration will also cause this to happen, which is what you need Leatherique for.

[Ssparrow]

That's kind of what I figured. How hard is it to swap out the seat cushion/leather bottom? I've been keeping my eye out for some used grey leather seats but haven't found any that are in better shape than mine are

[ClimRox]

Does anyone know the location of a good DIY for removing exterior B-pillar trim? I found this: http://www.bimmerfest.com/forums/sho...d.php?t=379663, however it is for an E39 so I don't know if it really applies.

[hcbeck2689]

Hope this is a good thread for this..
So I have been thinking about CAI awhile and have decided to do a little project based off of spoonerDee's DIY CAI thread http://www.zhpmafia.com/forums/showthread.php?t=6884

I have access to some aluminum sheet but also started thinking about lexan or plexiglass. How do you guys think that would look? Clear shield with metal angle on corners.
Thoughts..?


Sent from my iPhone using Tapatalk

[bshovers]

Is anyone running akg red tranny mounts?

Is anyone running Megan racing adjustable rear control arms?

Thoughts and opinions would be greatly appreciated before I pull the trigger on a good deal.


Sent from my iPhone using Tapatalk

[UdubBadger]

I'm running all AKG bushings on my M