Ok the last little task was making sure the positive cable in the drug bin wasn't rubbing on anything. I had to pop out the little tie down to make it reach the now top-mount terminal.
I was able to slide that tie mount back about an inch and pop it back into the body. Easy peasy.
But in reaching the new terminal, I had created a rub point on one of the brackets in the drug bin.
Just needed a little standoff that would keep the cable from vibrating on that point, so I grabbed a piece of plastic bracket that I had cut off earlier, put a few new holes in it, and boom standoff.
Now it's safe
Also learned that the hood switch is only used for the alarm system, which I don't have, so I removed it altogether. Could have saved a lot of time if I knew that from the start.
Reply With Quote