Did you see my comment on fb? You should make a cap instead of grinding the rest of the heat sink
Did you see my comment on fb? You should make a cap instead of grinding the rest of the heat sink
I only ground about 2mm total length on main fins. But rounded off the sides to match the profiles of the original lens
I have two sets of the x5 lights (ordering mistake) so if this first one doesn't work I should be ok with backup.
How would you make caps? Like use the caps that come on later headlights? I have a set of zkw e46 bixenon assembles. Maybe that rubber seal would fit?
- Stuart
/_________\
OO=[][]=OO
His: 05 330 ZHP Imola Red - 07 Z4 M Coupe Imola Red
Hers: 04 330i ZSP
2004 325 M56 Steel Blue Metallic - Sold
Stephen's DD & AutoX/HPDE Build Thread
Stewart WP - Z4M LCAB - M3 trans/motor mounts - DICE MediageBridge Duo - ARC-8 17x8.5"
DrVANOS - Mason Engineering Race Strut Bar - E30 Exp. Cap - Custom Black+Beige Interior - M3 Seats
Bilstein PSS10 - Turner Sway Bars 27/21 - ECST RTAB Limiters - R.E. RSM
Porsche 944 Turbo Build
One ride and you'll understand why most rocket scientists are German.
My ZHP Build 2004-2014 RIP
the x5 lights or the modded fogs?
- Stuart
/_________\
OO=[][]=OO
- Stuart
/_________\
OO=[][]=OO
All one assembly - now to test and see how the light pattern is - if all is good, I will move on to the left light
- Stuart
/_________\
OO=[][]=OO
Last edited by Hornung418; 07-16-2014 at 06:35 PM.
Porsche 944 Turbo Build
One ride and you'll understand why most rocket scientists are German.
My ZHP Build 2004-2014 RIP
they are selling them for like $60 for a pair right now
- Stuart
/_________\
OO=[][]=OO
- Stuart
/_________\
OO=[][]=OO