The Random E46/ZHP Question Thread

[ELCID86]

Ok. First gremlin that needs to be fixed IOT pass VA state inspection. the right livens plate bulb is out. Looks to have melted at some point. I'm not sure if this piece can be swapped or not. Can't seem to find it on realoem.
Left side works.
Any ideas?

[ELCID86]

I found a threat that recommends running wires from the other side and another that said just replace the whole $90 part.

[Hornung418]

You can buy the new piece and separate the painted piece and install that instead of paying for new paint.

Sent from my GS3.

[328ioc]

I found a threat that recommends running wires from the other side and another that said just replace the whole $90 part.

Looks like a good candidate for a junk yard part.

Sent from my SCH-I545 using Tapatalk

[ELCID86]

You can buy the new piece and separate the painted piece and install that instead of paying for new paint.

Sent from my GS3.

Looks like a good candidate for a junk yard part.

Sent from my SCH-I545 using Tapatalk

Thanks guys. I've been trying to separate the painted cover but man it doesn't want to come loose. Anyone ever done this? I can't find a DIY.
-----------------------

[Hornung418]

Hairdryer and a sharpened screwdriver. There are six clips holding it on. Work from the ends into the middle.

Sent from my GS3.

[ELCID86]

Hairdryer and a sharpened screwdriver. There are six clips holding it on. Work from the ends into the middle.

Sent from my GS3.

Thanks again Justin. I was able to pry one end apart just a bit. I need to get it disconnected from the car so I have an easier spot to work on it. I assume I need to drop the trunk liner IOT get to the wiring connector.

[Hornung418]

Thanks again Justin. I was able to pry one end apart just a bit. I need to get it disconnected from the car so I have an easier spot to work on it. I assume I need to drop the trunk liner IOT get to the wiring connector.

Yup. I couldn't do it when I was trying to fix mine...

Sent from my GS3.

[ELCID86]

Got it. Dropped the trunk liner and disconnected the trunk grip mechanism. Heat gun, flat tip and non-marring pry tool did the rest.

[Hornung418]

Nice!

Sent from my GS3.